Circuit Response
every model has an edge, and the figure carries it
Concept

Final value theorem — where it appears

The statement that a signal's settled value is the limit of s times its Laplace transform as s goes to zero. It reads a steady state off the transform without inverting it, and it returns a wrong number rather than an error when the transform has a pole in the right half-plane or on the imaginary axis away from the origin.

Named by 2 essays across one field — each of them below, with the objects they name alongside it.

A step on a series RLC at ζ = 0.079, and the two numbers read off H(s). computed by solving, not by drawing. A 50.3 kHz series RLC driven by a one-volt step, with the capacitor voltage and the inductor voltage drawn together. Two limits of the transfer function are two points of the waveform and neither needs the waveform: H(0) = 1.000000 is where the capacitor ends up, and H(∞) across the inductor is 1.0000, which is what it does at the first instant — the expansion gives 1.000000 for it at t = 0. Here the damping ratio is 0.0791, the response is inside ±2% after 7.6 cycles, and 100.0% of the last twenty-four cycles sit there. The poles are at a real part of -7.91e-2 of ω₀, which is the condition the final-value theorem actually has — not a property of H but of where sY(s) has its poles.

Two numbers without solving for the waveform

Where a step response starts and where it ends are two limits of the transfer function, and neither needs the waveform. Both are exact here — 1.000000000 volts at the end and the whole step at the first instant — and one of them is a lie waiting to happen: take the damping to zero and the final-value theorem still returns 1.000000 for a response that swings between 0 and 2 for ever. Its condition is not on the transfer function but on where the poles are, and the practical condition is narrower still: at five ohms the poles are safely in the left half-plane and sixty cycles is not enough time.

transients · Value theorems A step through r sections starts as (t/τ)^r: it reaches 1% at 10.1 µs, 105 µs, 243 µs, 380 µs, 508 µs for r = 1 to 5. Solved, and expanded two ways. The step response of buffered RC sections of time constants τ, τ/2, … τ/r, with τ = 1 ms, on logarithmic axes. The relative degree of the recovered transfer function is r, so the first r − 1 derivatives of the step are zero at the start and the r-th is lim s^r·H(s) = r!/τ^r, read off the network solved far above its poles and off the expansion of H about infinity; the step therefore starts as (t/τ)^r, a straight line of slope r. The expansion about infinity and the residue expansion agree to a part in a million where both are well conditioned. The output reaches 1% at 10.1 µs (r = 1), 105 µs (r = 2), 243 µs (r = 3), 380 µs (r = 4), 508 µs (r = 5), and half its final value at 693 µs, 1.23 ms, 1.58 ms, 1.84 ms, 2.04 ms. For these time constants the whole step is (1 − e^(−t/τ))^r, checked against both expansions, so the time to a fraction ε is −τ·ln(1 − ε^(1/r)).

The start a step takes from infinity

The initial-value theorem reads where a step starts off H at infinite frequency. Apply it again to s·H, s²·H and on, and it reads how the step starts: the first r − 1 derivatives are zero for a network r degrees more poles than zeros, and the r-th is the ratio of the leading coefficients. So a step through r sections begins as a power of time — for sections of τ, τ/2, … τ/r, exactly (t/τ) to the r — and reaches one per cent at 10.1 µs through one section, 105 µs through two and 508 µs through five. Put a zero anywhere, even a thousand times above every pole, and the step starts linearly instead, with a slope of twice the zero's time constant over τ² that is the larger term for the first two of them.

transients · Value theorems

Named alongside it

The objects these essays reach for when they reach for this one.

Initial-value theoremPolesResiduesSettling timeTransfer functionLossless networkStep responseTrapezoidal rule

All concepts