Generator

The quietest capacitor is 18× the fastest one, and the margin prefers neither

computed by solving, not by drawing. The total noise at the load of a capacitively loaded stage against its compensation capacitor, with the settling time on the same axis at ten microseconds to the microvolt. Three independent sources are put in the netlist and solved separately — the amplifier's own 4 nV/√Hz at its input, and √(4kTR) in series with each of the two feedback resistors — and added in power. The noise falls monotonically with the capacitor, from 50.7 µV at 1 pF to 12.1 µV at 220 pF. The peak in the noise gain falls with every larger capacitor and is gone entirely from 12 pF upward, where the uncompensated stage's peaks at 3.85 times its own low-frequency value. What the capacitor costs is settling: the fastest is 12 pF at 0.74 µs — the same capacitor that flattens the noise gain, because one handover decides both — and the quietest takes 20.3 µs, at a margin above 40° everywhere in that range.
The quietest capacitor is 18× the fastest one, and the margin prefers neithercomputed by solving, not by drawing. The total noise at the load of a capacitively loaded stage against its compensation capacitor, with the settling time on the same axis at ten microseconds to the microvolt. Three independent sources are put in the netlist and solved separately — the amplifier's own 4 nV/√Hz at its input, and √(4kTR) in series with each of the two feedback resistors — and added in power. The noise falls monotonically with the capacitor, from 50.7 µV at 1 pF to 12.1 µV at 220 pF. The peak in the noise gain falls with every larger capacitor and is gone entirely from 12 pF upward, where the uncompensated stage's peaks at 3.85 times its own low-frequency value. What the capacitor costs is settling: the fastest is 12 pF at 0.74 µs — the same capacitor that flattens the noise gain, because one handover decides both — and the quietest takes 20.3 µs, at a margin above 40° everywhere in that range.10110100compensation capacitor Cf (picofarads)noise at the load (µV rms), and settling time (µs)fastest: 12 pFuncompensated: 54.9 µVnoise falling, settling risingisolation resistor10 Ωload capacitor2.2 nFamplifier4 nV/√Hzno compensation54.87 µV…its noise gainpeaks at 3.85resistor alone42.21 µVnoise gain flat from12 pFfastest settling12 pF…noise there28.87 µVquietest drawn220 pF…settling there20.25 µssolved, then checked — three noise sources, each solved in the netlistno peak left above 12 pF

Drawn above at its default parameters, which is almost never how an essay calls it. A placement states the numbers that essay is arguing about, so the figure a reader meets is about that argument rather than about the generator — 98% of the placements on this site pass one, and the phase that raised that number from 12% found eight captions describing a figure the page was not showing.

At those defaults the edge it states is no peak left above 12 pF — the right-hand slot of the caption strip, which on this site is never used for anything else, and which is read back out of the drawing above rather than out of the code that wrote it. It belongs to Feedback, and the margin, which is to say a change to it is a change to lib/figures/feedback.js. It takes a slider on load capacitance (nF) with 6 settings, and every one of them has passed the same assertions as the frame above — a figure whose circuit stops doing what its caption says at any setting stops the build.

Called by 3 essays

which is the blast radius of changing it

What the second path costs at the floor

The arrangement that repaired a capacitively loaded amplifier was suspected of paying for itself in noise, because that is how compensations usually pay. It does not: it has no peak in its noise gain at all, and the total at the load falls from 54.9 microvolts to 28.9 as the capacitor is added. What it costs is settling, and the capacitor that is quietest is eighteen times the capacitor that settles fastest — a trade the phase margin says nothing about, because the margin is comfortable at both.

Feedback, and the margin

The current above which there is no impedance

The sixth rung found the impedance leaving at 10.6 mA, where the input pair's own tanh takes over and the slew rate is twice the thermal voltage times the gain-bandwidth in radians, with no design choice in it. A real output stage has a second limit that is nothing but design choice, and the two do not bind at the same load: at 0.47 nF the input pair's departure is 19.4 per cent against the output stage's 4.2, at 22 nF it is 0.9 against 2.3, and above the output stage's rating the excursion does not come back at all — 2,254 Ω for a quantity that was 37.

Feedback, and the margin

The window the resistors own

Eight essays have priced one compensated stage, and the fourth of them left two of the amplifier's own generators named and uncounted. With the current generator put in the netlist the floor at ten kilohms goes from 28.88 microvolts to 30.13, and the resistors carry more than half the noise power only between 2.91 kΩ and 85.9 kΩ — outside that window, in both directions, the part does. The flicker corner turns out to be worth 1.00009 in this stage's own band, and 3.474 one band away.

Feedback, and the margin

Every generator