The 0.7 volt constant, solved over eight decades of current
Drawn above at its default parameters, which is almost never how an essay calls it. A placement states the numbers that essay is arguing about, so the figure a reader meets is about that argument rather than about the generator — 98% of the placements on this site pass one, and the phase that raised that number from 12% found eight captions describing a figure the page was not showing.
At those defaults the edge it states is the constant moves 59.5 mV per decade — the right-hand slot
of the caption strip, which on this site is never used for anything else, and which is read
back out of the drawing above rather than out of the code that wrote it.
It belongs to Where the models stop, which is to say a change to it is a
change to lib/figures/limits.js.
It takes a slider on ideality factor with 5 settings,
and every one of them has passed the same assertions as the frame above — a figure whose
circuit stops doing what its caption says at any setting stops the build.
Called by 13 essays
which is the blast radius of changing it
A bias point is a solution, not a choice
The phrase "the diode drops 0.7 volts" is a constant standing in for the root of a transcendental equation. Solved properly, from a five-volt supply through a kilohm, it drops 0.692544 V — and from forty-eight volts through the same kilohm it drops 0.754459 V, because the drop moves about sixty millivolts for every decade of current through it.
The amplitude nothing linear predicts
A linear model's poles say the envelope grows by 1.88 a cycle and never say when it stops. Two diodes across the feedback resistor stop it, at 858 millivolts — a number no pole, no transfer function and no bias point contains. Getting it needs a netlist with a nonlinearity in it, marched forward in time, and that pairing is what the whole field is built on.
How small is small signal
Linearising an exponential replaces a curve by its tangent, which is exact at a point and progressively wrong away from it. The amplitude at which it is one per cent wrong is 7.3 millivolts at room temperature — 28 per cent of the thermal voltage, not a small fraction of it, and a good deal smaller than "small signal" suggests.
The one current a constant is right at
Seven-tenths of a volt is the true forward drop at 5.748 milliamperes and at no other current, and every circuit built on it crosses zero error there — four different resistors at four different supplies, all exact at the same current. What decides whether the model is any good is not the diode at all; it is how much of the supply the diode is taking.
A band rather than an edge
Every other boundary in this collection is one-sided: a model is true below a frequency, or below an amplitude. A switch is a switch only for loads between 49.5 ohms and 1.01 megohms — bounded at both ends by the same part — and the upper end is a frequency as well as a resistance, so the band narrows as the frequency rises and shuts completely at 6.43 megahertz, above which no load resistance at all will do.
The constant that is a window
A diode's ideality factor is quoted as a number and defined as a derivative, which means it has a value at every current and no value anywhere. Eight one-decade fits to one curve return factors from 1.23 to 1.98, two of them straight to a few parts in a thousand — so the residual gives no warning at all. Asked for the forward voltage at a milliamp, the window containing it is right to a third of a millivolt and the worst is out by 186, which is a current a hundredth of the truth.
Two currents with one name
A junction's saturation current is two currents with one name. The one in the forward law doubles every 4.49 kelvin; the one a reverse-biased junction actually conducts is generated in its depletion region, doubles every 8.98, and on this model junction is 3.06 × 10⁵ times larger at a volt of reverse bias. Doubles every ten kelvin is the second current's rule, and applied to the first it turns the forward drop's −1.81 millivolts per kelvin into +0.39.
The exponent that is a square
Every device in this collection so far has been an exponential, and the whole of its arithmetic — 59.5 millivolts a decade, a distortion edge at 1.03 millivolts, 3,333 parts per million a kelvin — comes out of that one law. A field-effect device obeys a different one, and the interesting part is that it obeys both: an exponential below threshold and a square above it. The square law is within one per cent over a factor of 1.06 in overdrive at half a micron, and the two errors that bound it point opposite ways.
The resistance a slow curve cannot see
A diode's series resistance is read off the top of its forward curve, and a bench curve is a slow one: each point is held until the junction has warmed to it. Through 350 kelvin per watt the held curve sits 39.7 millivolts below the pulsed one at 100 milliamps, and the three-parameter fit that reads 0.580 ohms from the pulsed curve reads 0.184 from the held one — with a smaller residual. The fitted resistance reaches zero at 531.7 kelvin per watt, and the resistance it hid is what keeps the junction from folding back: with 0.05 ohms instead of 0.6 the held curve turns over at 87.6 milliamps.
The logarithm is in the collector
A diode is the textbook logarithm, and a real junction holds one to within one per cent over only 2.40 decades — from 50 nanoamps to 12.6 microamps, at an ideality of 1.98 — because two mechanisms and a series resistance share its terminals. The same junction read at a transistor's collector, with its recombination current supplied from the base, holds 8.50 decades at an ideality of 1.0001. How far the logarithm reaches is decided by which terminal the current is taken from, and at the bottom of the range by a leakage current a millivolt is enough to switch on.
Two exponentials, and where they meet
An oscillator's envelope grows by exp(π(k−3)/√(1 − ((k−3)/2)²)) a cycle, and the form usually quoted drops the denominator — exact to four parts in ten million at a hundredth above three, and 20.462 per cent low at 3.8, which is precisely where too few small cycles are left to measure it. Where the growth stops is the diode's own exponential: 108.5 millivolts of amplitude for every decade of saturation current, proportional to the ideality to four parts in a thousand. Above 60.121 nanoamperes the limiter is already conducting at zero signal and there is no oscillation at all.
The straight line between two models
Between a constant seven-tenths of a volt and an exponential sits the model a designer actually reaches for: a drop plus a resistance. Fitted so that its worst error over a decade of current is as small as it can be, it is out by ±8.00 millivolts where the best constant is out by ±29.76 — and both numbers are the same over every decade, because a decade of a logarithm is the same shape wherever it is taken. On a real two-mechanism junction the line does best in the top decade, ±8.71 against a constant's ±58.53, because a series resistance is exactly the term the line has and the constant has none. And the resistance the fit returns is the part's plus 701 milliohms that is not there.
The sensor inside its own answer
A junction driven from a current source cannot run away, because its forward voltage falls with temperature and its loop gain is therefore negative. What that costs is a thermometer that is warmer than what it is measuring by 4.26 kelvin at ten milliamperes, and — the part a calibration cannot remove — under-reports every change in ambient by 9,584 parts per million, because the sense current's own dissipation falls as the reading rises. Calibrated at 25 degrees, it is out by 583 millikelvin at 85.