Started from a millivolt at a gain of 3.20
Drawn above at its default parameters, which is almost never how an essay calls it. A placement states the numbers that essay is arguing about, so the figure a reader meets is about that argument rather than about the generator — 98% of the placements on this site pass one, and the phase that raised that number from 12% found eight captions describing a figure the page was not showing.
At those defaults the edge it states is the growth is linear; the amplitude is not — the right-hand slot
of the caption strip, which on this site is never used for anything else, and which is read
back out of the drawing above rather than out of the code that wrote it.
It belongs to Circuits that do a job, and the range they do it over, which is to say a change to it is a
change to lib/figures/applied.js.
It takes a slider on closed-loop gain, 1 + Rf/Rg with 6 settings,
and every one of them has passed the same assertions as the frame above — a figure whose
circuit stops doing what its caption says at any setting stops the build.
Called by 5 essays
which is the blast radius of changing it
The amplitude nothing linear predicts
A linear model's poles say the envelope grows by 1.88 a cycle and never say when it stops. Two diodes across the feedback resistor stop it, at 858 millivolts — a number no pole, no transfer function and no bias point contains. Getting it needs a netlist with a nonlinearity in it, marched forward in time, and that pairing is what the whole field is built on.
What the limiter charges for
The diodes that set the amplitude are the only nonlinear thing in the loop, so every harmonic in the output is theirs. Across the gain slider the amplitude rises by a factor of 1.51 and the distortion by 15.4 — an amplitude that goes as the 0.11 power of the excess gain and a distortion that goes as the 0.74 power. Two diodes facing opposite ways produce no even harmonic at all, at seven parts in ten million, which is the arithmetic's floor rather than a small residue.
The frequency that is not the formula
The Wien network's zero-phase frequency is one over two pi RC to every digit the arithmetic has. The circuit does not run there. With a perfect amplifier it runs 0.771 per cent low, because the limiter's harmonics are part of the waveform whose period is being measured; with a real one it runs lower still, by an amount inversely proportional to the gain-bandwidth product. The two are equal at a ratio of 578, and above that a faster amplifier buys nothing.
The input that pushes back
An emitter follower with a capacitor on its emitter has a negative resistance looking into its base — 1182 ohms of it at 3.4 megahertz for a nanofarad, with nothing added to the model. A negative resistance is not an oscillator until a reactance cancels, and the base lead supplies it: with ten ohms of source the loop goes unstable above 74.9 nanohenries, which is seven centimetres of wire. The repair is the opposite of the instinct — a hundred ohms of source raises the threshold to 913 nanohenries, so the fix for a follower that oscillates is to make the thing driving it worse.
Two exponentials, and where they meet
An oscillator's envelope grows by exp(π(k−3)/√(1 − ((k−3)/2)²)) a cycle, and the form usually quoted drops the denominator — exact to four parts in ten million at a hundredth above three, and 20.462 per cent low at 3.8, which is precisely where too few small cycles are left to measure it. Where the growth stops is the diode's own exponential: 108.5 millivolts of amplitude for every decade of saturation current, proportional to the ideality to four parts in a thousand. Above 60.121 nanoamperes the limiter is already conducting at zero signal and there is no oscillation at all.