Circuit Response
every model has an edge, and the figure carries it
Generator

A 10 kΩ resistor, and the 19.3 MHz it is one below

computed by solving, not by drawing. The dashed line is R, which is what the symbol means. The solid line is the same part with 8.0 nH of lead inductance in series and 0.40 pF across the body, solved as a three-element network and checked against the closed form for the same three elements to 3.3e-16. It is ten per cent below its own value by 19.3 MHz, and which of the two parasitics does that depends on the resistance: the shunt capacitance wins above 91.02 Ω and the lead inductance below it. The slider is the resistance, and the departure frequency it moves is not monotonic — it rises a decade per decade of resistance, peaks near 91.02 Ω at 2.00 GHz, and falls a decade per decade after that.
A 10 kΩ resistor, and the 19.3 MHz it is one belowcomputed by solving, not by drawing. The dashed line is R, which is what the symbol means. The solid line is the same part with 8.0 nH of lead inductance in series and 0.40 pF across the body, solved as a three-element network and checked against the closed form for the same three elements to 3.3e-16. It is ten per cent below its own value by 19.3 MHz, and which of the two parasitics does that depends on the resistance: the shunt capacitance wins above 91.02 Ω and the lead inductance below it. The slider is the resistance, and the departure frequency it moves is not monotonic — it rises a decade per decade of resistance, peaks near 91.02 Ω at 2.00 GHz, and falls a decade per decade after that.1101001k10k100k10k100k1M10M100M1Gfrequency (hertz)impedance magnitude (ohms)R, the symbol's promise10% low above 19.3 MHz6 mm is 1° long heresolved, then checked — R, its lead and its bodya resistance below 19.3 MHz

Drawn above at its default parameters, which is almost never how an essay calls it. A placement states the numbers that essay is arguing about, so the figure a reader meets is about that argument rather than about the generator — 98% of the placements on this site pass one, and the phase that raised that number from 12% found eight captions describing a figure the page was not showing.

At those defaults the edge it states is a resistance below 19.3 MHz — the right-hand slot of the caption strip, which on this site is never used for anything else, and which is read back out of the drawing above rather than out of the code that wrote it. It belongs to Frequency, which is the same solve, which is to say a change to it is a change to lib/figures/frequency.js. It takes a slider on resistance (ohms) with 7 settings, and every one of them has passed the same assertions as the frame above — a figure whose circuit stops doing what its caption says at any setting stops the build.

Called by 3 essays

which is the blast radius of changing it

The mismatch that the cable hides

A lossless line carries a reflection back unchanged, so the standing-wave ratio at the instrument is the standing-wave ratio at the load. A real line does not, and the departure is exact: ten decibels of one-way loss improves any mismatch by twenty. A four-to-one load at the end of twenty metres of ordinary coaxial cable measures 1.13 at the near end, a return loss of 24 decibels, and passes an acceptance test the load could never pass. The boundary is a loss rather than a length, which makes it a frequency: 30.2 metres at 100 megahertz, 9.5 at a gigahertz, 3.0 at ten.

Lines, where a wire has a length

The resistor that is only a resistor

A capacitor becomes an inductor above a frequency its leads decide, and an inductor becomes a capacitor. The third member of that family is the one nobody draws, and it is the only one whose edge is not monotonic in its own value: a ten-megohm resistor stops being one at 19 kilohertz, a ten-ohm resistor at 92 megahertz, and between them sits a resistance whose impedance is flat to fourth order — 91.02 ohms here, which is the square root of L over C divided by the root of one plus root two.

Frequency, which is the same solve

The resistor that is right in size and wrong in angle

A resistor's impedance departs from its value in size as the square of frequency and in angle as the first power, so the angle always leaves first: at ten milliohms and at a megohm alike, where the angle has reached a degree the size is still only 152 parts per million out. One time constant, L/R − RC, sets that degree — 4.00 nanoseconds and 695 kilohertz at ten kilohms, 800 nanoseconds and 3.47 kilohertz for a ten-milliohm shunt. The resistance flattest in angle is exactly √(L/C), 141.42 ohms, the value the size question rejected; at the 91.02 ohms flattest in size the angle reaches a degree by 53.9 megahertz, and no resistance is flat in both.

Frequency, which is the same solve

Every generator