Five steps, each divided by its own size, from an amplifier limited to 0.50 V/µs
Drawn above at its default parameters, which is almost never how an essay calls it. A placement states the numbers that essay is arguing about, so the figure a reader meets is about that argument rather than about the generator — 98% of the placements on this site pass one, and the phase that raised that number from 12% found eight captions describing a figure the page was not showing.
At those defaults the edge it states is scaling fails above a 79.6 mV step — the right-hand slot
of the caption strip, which on this site is never used for anything else, and which is read
back out of the drawing above rather than out of the code that wrote it.
It belongs to Before the steady state, which is to say a change to it is a
change to lib/figures/transients.js.
It takes a slider on slew rate (volts per second) with 7 settings,
and every one of them has passed the same assertions as the frame above — a figure whose
circuit stops doing what its caption says at any setting stops the build.
Called by 4 essays
which is the blast radius of changing it
The ideal amplifier, and where it stops being one
An ideal operational amplifier's closed-loop gain is set by two resistors and nothing else — a horizontal line at every frequency. The real one is already a tenth of a per cent low at direct current, one per cent low by 1.35 kHz, and above 10 kHz has no loop gain left, at which point the ideal answer is not an approximation to anything.
The step that is too big
A linear circuit scales — double the input and the output doubles, exactly. A real amplifier does not, because its output can only move at a fixed rate, and the amplitude at which the two stop agreeing is about eighty millivolts for an ordinary part. No transfer function contains that number, because no transfer function can.
The diode that conducts backwards
Every diode in this collection is an instantaneous function of its own voltage, which is exact for an operating point and has no time in it at all. A conducting junction holds a charge, and until that charge is gone it cannot block: drive its current down at a hundred amperes a microsecond and it conducts 3.83 amperes backwards for 48 nanoseconds, against the one ampere it was carrying forwards. The expression every reference gives for that peak is 17 per cent high there, and is right to a per cent only above sixteen thousand amperes a microsecond.
The current above which there is no impedance
The sixth rung found the impedance leaving at 10.6 mA, where the input pair's own tanh takes over and the slew rate is twice the thermal voltage times the gain-bandwidth in radians, with no design choice in it. A real output stage has a second limit that is nothing but design choice, and the two do not bind at the same load: at 0.47 nF the input pair's departure is 19.4 per cent against the output stage's 4.2, at 22 nF it is 0.9 against 2.3, and above the output stage's rating the excursion does not come back at all — 2,254 Ω for a quantity that was 37.