An exponential: distortion arrives seven times sooner than gain error
Drawn above at its default parameters, which is almost never how an essay calls it. A placement states the numbers that essay is arguing about, so the figure a reader meets is about that argument rather than about the generator — 98% of the placements on this site pass one, and the phase that raised that number from 12% found eight captions describing a figure the page was not showing.
At those defaults the edge it states is 7.1× apart — the right-hand slot
of the caption strip, which on this site is never used for anything else, and which is read
back out of the drawing above rather than out of the code that wrote it.
It belongs to Devices, and where they stop being linear, which is to say a change to it is a
change to lib/figures/semi.js.
Its slider chooses between 3 named cases rather than sweeping a number
— device — so this page shows one of them and the essays that
place it choose which. Each case asserts its own claims: a figure that branches on what it
draws has to branch its description too, which is a lesson this site learned by shipping one
that did not.
Called by 7 essays
which is the blast radius of changing it
The distortion a linear model cannot have
A small-signal model's output is a scaled copy of its input by construction, so it has no second harmonic and asking it for one is not a hard question but a meaningless one. Measured on the curve itself, an exponential produces one per cent of harmonic distortion at 1.03 mV of drive — seven times sooner than the 7.30 mV at which its gain is one per cent wrong.
A floor and a ceiling
Every other boundary on this site is a ceiling. This one puts a floor underneath and measures the distance between them — 4.00 nanovolts per root hertz at the bottom, one per cent of harmonic distortion at 1.03 millivolts at the top, and 66.3 decibels of range in a ten-kilohertz measurement. Both ends are computed, neither is on a datasheet, and the arrangement of the stages decides which one moves.
What a resistor in the emitter buys
Degeneration is described as a trade: give up gain, get linearity. Measured on the transfer curve, the two sides of that trade are not the same size. Dividing the gain by six moves the amplitude at which distortion reaches one per cent by thirty-five times — the square of the factor — and the amplitude at which the gain is one per cent out by only twelve. So the two edges close up, and a well-degenerated stage stops being limited by its linearity and starts being limited by how accurately its gain is known.
Where the two exponents come from
What a resistor in the emitter buys measured two exponents and could explain neither: the distortion edge moves as the square of the degeneration factor and the gain edge as its 0.950 power, and at a factor of exactly three halves the gain error vanished. The degenerated transfer curve has no closed form forwards and an exact one backwards, and reverting that series gives all three. The distortion exponent is exactly two; the gain edge is proportional to D squared over the root of the absolute value of three minus twice D, which is infinite at three halves and tends to a three-halves power; and the two edges are 7.07 apart on the bare device and 1.62 at a factor of eleven, against 7.06 and 1.61 measured.
What the fourth order says about the third
A closed form derived by neglecting the fourth-order term is a claim with an error, and the error is a quantity the fourth-order term can be asked about. Carried one order further, the degenerated exponential's reversion predicts 7.33 per cent where the leading expression was measured to be 6.89 per cent optimistic — and takes the residue to 0.362 per cent. The correction has its own edge, in the same quantity, and it is measured too.
The order that stops helping
Three essays in this field have derived expressions for the amplitude at which a degenerated stage's distortion reaches a target, each one order longer than the last, and each one nearer the measurement. This is where that stops. The error of an expression truncated at order m grows as the m-th power of the drive — 2.00, 4.00 and 5.88 measured — so every added order buys a range that ends sooner than the last one bought, and above 8.9 thermal voltages the six-term expression is further from the device than the four-term one.
The device that never sees the swing
A second transistor standing between the first and the load does two things that every reference gives one expression each for, and one of the two expressions has no ceiling in it. The output resistance is not gₘrₒ² — that is 248 megohms here, and the measurement is 11.5 — it is βrₒ, because the upper device's base draws current and shunts the very node the feedback works through. The bandwidth really is fourteen times better, and what it costs is two volts of a five-volt supply.