Circuit Response
every model has an edge, and the figure carries it
Series

Dispersion — the series

2 essays on one idea, from the one that introduces it to the one that assumes the rest.
  1. Below 910 kHz a trace is a diffusion, not a line — and its velocity goes as √f. computed by solving, not by drawing. The phase velocity of an ordinary FR-4 trace against frequency, computed from γ = √((R + jωL)(G + jωC)) with a series resistance that rises as √f above its skin-effect corner and a shunt conductance proportional to frequency. Above 910 kHz the velocity is 0.4767c and does not move, which is the number every other essay in this field uses. Below it the series resistance dominates the reactance, the line is a diffusion, and the velocity falls as the square root of frequency — measured at the 0.467 power. The characteristic impedance is not a constant down there either: 1508 Ω at a kilohertz against 50.0 Ω at ten gigahertz.

    The delay that is not one number

    Nine essays in this field quote a delay: a length divided by a velocity, the same for every frequency, and the edge that comes out is the edge that went in. A real trace has a series resistance, and below the frequency where the reactance overtakes it — 910 kilohertz for ordinary copper — the line is a diffusion rather than a wave, with a velocity proportional to √f. What survives is that the arrival is still exactly linear in the length. What does not is the rise time, which grows as the square of it.

    part 1 · lines
  2. A permittivity quoted as one number falls 0.645 across five decades. computed by solving, not by drawing. The real part of the relative permittivity against frequency for FR-4 (ε′ = 4.4 at 1 GHz, tanδ = 0.02), from a continuum of relaxations spread uniformly in log-frequency — the arrangement that makes the loss tangent flat. The dashed line is the single number a datasheet quotes. FR-4: 4.787 at 1 MHz and 4.142 at 100 GHz, a fall of 14.7 per cent. Nothing here is fitted: the slope is what a flat loss tangent forces.

    The permittivity a loss forbids

    A datasheet quotes a relative permittivity and a loss tangent as two independent numbers, and they are not two numbers. A material that dissipates has a permittivity that falls logarithmically with frequency at a rate its own loss fixes — 0.129 of permittivity a decade for FR-4, so the 4.4 quoted at a gigahertz is 4.79 at a megahertz and 4.14 at a hundred. Three hundred millimetres of track loses 62.9 picoseconds of delay between 100 MHz and 10 GHz, which a constant permittivity puts at 1.3; and the constant-permittivity model smears an edge backwards, taking 180 picoseconds to reach half height and 133 more to reach nine tenths.

    part 2 · lines

All series