Circuit Response
every model has an edge, and the figure carries it
Series

Emitter degeneration — the series

4 essays on one idea, from the one that introduces it to the one that assumes the rest.
  1. An exponential with 6× of degeneration: both edges move, and not together. computed by solving, not by drawing at 61 amplitudes. Total harmonic distortion reaches one per cent at 36.6 mV and the gain falls one per cent short of its small-signal value at 85.0 mV. An emitter resistor dividing the gain by 6 moves the distortion edge by 35.4 times — the square of the factor, because the resistor both divides the drive reaching the junction and linearises what the junction does with it — while the gain edge moves by only 11.6 times. So the two edges close up: 2.32 times apart here against 7.06 bare, and a well-degenerated stage stops being limited by its linearity and starts being limited by how accurately its gain is known.

    What a resistor in the emitter buys

    Degeneration is described as a trade: give up gain, get linearity. Measured on the transfer curve, the two sides of that trade are not the same size. Dividing the gain by six moves the amplitude at which distortion reaches one per cent by thirty-five times — the square of the factor — and the amplitude at which the gain is one per cent out by only twelve. So the two edges close up, and a well-degenerated stage stops being limited by its linearity and starts being limited by how accurately its gain is known.

    part 1 · semiconductors
  2. An exponential with 6× of degeneration: both edges move, and not together. computed by solving, not by drawing at 61 amplitudes. Total harmonic distortion reaches one per cent at 36.6 mV and the gain falls one per cent short of its small-signal value at 85.0 mV. An emitter resistor dividing the gain by 6 moves the distortion edge by 35.4 times — the square of the factor, because the resistor both divides the drive reaching the junction and linearises what the junction does with it — while the gain edge moves by only 11.6 times. So the two edges close up: 2.32 times apart here against 7.06 bare, and a well-degenerated stage stops being limited by its linearity and starts being limited by how accurately its gain is known.

    Where the two exponents come from

    What a resistor in the emitter buys measured two exponents and could explain neither: the distortion edge moves as the square of the degeneration factor and the gain edge as its 0.950 power, and at a factor of exactly three halves the gain error vanished. The degenerated transfer curve has no closed form forwards and an exact one backwards, and reverting that series gives all three. The distortion exponent is exactly two; the gain edge is proportional to D squared over the root of the absolute value of three minus twice D, which is infinite at three halves and tends to a three-halves power; and the two edges are 7.07 apart on the bare device and 1.62 at a factor of eleven, against 7.06 and 1.61 measured.

    part 2 · semiconductors
  3. The fourth-order term explains 95% of what the third leaves out. computed by solving, not by drawing. Two closed forms for the amplitude at which a degenerated stage reaches 1% of second harmonic, each against the same measurement — a bisection on the harmonic content of a Newton-solved curve, which shares no arithmetic with either. The leading expression is 4Vₜ·t·D², derived at the rung below this one and exact in the limit of small drive; its error grows as the 1.96 power of the drive it is evaluated at. At a degeneration of eleven that drive is 4.53 thermal voltages and the expression is 6.89% optimistic. Carrying the reversion one order further takes it to 0.362%.

    What the fourth order says about the third

    A closed form derived by neglecting the fourth-order term is a claim with an error, and the error is a quantity the fourth-order term can be asked about. Carried one order further, the degenerated exponential's reversion predicts 7.33 per cent where the leading expression was measured to be 6.89 per cent optimistic — and takes the residue to 0.362 per cent. The correction has its own edge, in the same quantity, and it is measured too.

    part 3 · semiconductors
  4. Every order buys less range than the one before, and above 9 Vₜ the sixth is worse than the fourth. computed by solving, not by drawing. The error of the same expression truncated at three orders, against the drive it is evaluated at, with the measurement it is chasing being a Newton-solved transfer curve that knows about no series at all. Each truncation's error grows as its own order in the drive — fitted at 2.00, 4.00, 5.88 against 2, 4 and 6 — so each buys a further range at a stated accuracy: inside 1% the leading expression is good to 1.12 thermal voltages, the fourth order to 3.88 and the sixth to 7.03, factors of 3.46 and 1.81. Beyond all of them the series stops helping: at 8.9 thermal voltages, where the second harmonic is 11.4%, the sixth-order expression is exactly as wrong as the fourth and is worse above it. What a designer does there is bisect the curve.

    The order that stops helping

    Three essays in this field have derived expressions for the amplitude at which a degenerated stage's distortion reaches a target, each one order longer than the last, and each one nearer the measurement. This is where that stops. The error of an expression truncated at order m grows as the m-th power of the drive — 2.00, 4.00 and 5.88 measured — so every added order buys a range that ends sooner than the last one bought, and above 8.9 thermal voltages the six-term expression is further from the device than the four-term one.

    part 4 · semiconductors

All series