Circuit Response
every model has an edge, and the figure carries it
Series

Phasors — the series

3 essays on one idea, from the one that introduces it to the one that assumes the rest.
  1. Three element voltages closing on one source, at 1.59 kHz. Solved at 1.59 kHz, which is 1.00× the frequency at which the two reactances cancel. The three phasors add head to tail to the 1 V source exactly; their magnitudes sum to 5.26 V, which is not the same statement.

    Three voltages that close on one, and the steady state they assume

    Kirchhoff's voltage law drawn as a polygon in the complex plane. The three element voltages of a series circuit add head to tail to the source exactly — while their magnitudes add to five times it. And the whole picture is a statement about a settled circuit, which takes a computable number of cycles to arrive.

    part 2 · frequency
  2. Switched on at 0.95× resonance, a Q 50 capacitor reaches 1.550 times its settled voltage. computed by solving, not by drawing. The capacitor voltage of the series circuit, switched on from rest at the crest of the drive, drawn as the tip of its arrow in the frame that turns with the drive, so that the settled state is a fixed point — the arrow from the centre, 10.067 V long, with the circle of that radius around the centre. The path is the settled arrow plus a second one turning at the circuit's own frequency and shrinking, drawn until the second is a hundredth of its first length. The voltage reaches 15.603 V in cycle 9, 1.5499 times the settled amplitude, and the tip's farthest point is 1.5499 times it. The approximation 1 + exp(−π/2Q|δ|) gives 1.5335. Marched in time by the trapezoidal rule, the network agrees with the exact solution to 1.2e-3 of the settled amplitude over its first 11 cycles.

    The arrow that goes past where it settles

    A phasor is where a driven resonator ends up, and counting the cycles it takes to get there says nothing about the path. Switched on from rest a little away from resonance, the capacitor's arrow circles its settled tip instead of approaching it: a Q of 50 driven at 0.8 of resonance reaches 1.854 times its settled voltage, and a Q of 200 at 1.25 switched on through zero reaches 2.182. At resonance exactly, where the settled voltage is largest, the arrow never passes its mark. So a resonance read by the largest voltage after switch-on is 1.20 times wider than its phasor says.

    part 3 · frequency
  3. A Q 10 resonance read by a stepped sweep is within 1% of its width after 1.65Q cycles a step. computed by solving, not by drawing. A stepped sweep switches the series circuit on from rest at each of 201 frequencies, waits a stated number of cycles of resonance, and reads the largest capacitor voltage in the last cycle of the wait; the resonance's half-power width is then bisected on those readings and compared with the settled width, 0.1003 of the resonant frequency. After Q cycles the reading is 19.6% too wide and its peak 4.66% low. The width stays within 1% from 1.65Q cycles on and the peak from 1.50Q, against the ln(100)/π = 1.466Q cycles the second arrow takes to fall to a per cent. A reading that holds its largest value instead is 20.2% too wide at any dwell, since the overshoot it holds has already happened.

    How long a sweep waits at each step

    A resonance measured by a stepped sweep that starts each frequency from rest and reads the last cycle of its wait comes out 19.6 per cent too wide after Q cycles a step, and within one per cent of its width only from 1.65Q cycles at a Q of ten and 1.60Q at fifty. That is longer than the 1.47Q the transient takes to fall to a per cent, and the reason is the centre rather than the skirts: the width's error is the peak's shortfall read twice, while at the half-power frequencies the transient swings through its settled value and partly cancels itself. A reading that holds its peak instead is twenty per cent wide however long it waits.

    part 4 · frequency

All series