Circuit Response
every model has an edge, and the figure carries it
Series

Resonance — the series

5 essays on one idea, from the one that introduces it to the one that assumes the rest.
  1. A resonant circuit of Q = 8, and its measured bandwidth. The half-power points are 1.50 kHz and 1.69 kHz, a bandwidth of 198.9 Hz. The components predict f₀/Q = 198.9 Hz. They differ by 0.000%.

    Resonance, and the bandwidth it sets exactly

    The half-power bandwidth of a resonant circuit is f₀/Q — not approximately, but to every digit the arithmetic has, which is rare enough to be worth checking. What is not exact, and is drawn as though it were, is the idea that the band sits centred on the resonance. At a quality factor of one its middle is twelve per cent above.

    part 2 · frequency
  2. A resonator's Q against its inductor's, with a capacitor of Q 1581. computed by solving, not by drawing. The dashed line is what the resonator's Q would be if the inductor were its only loss; the solid one is what it is with a capacitor of Q 1581 beside it. They part company where the inductor stops being the worst component. At the marked point the inductor's Q is 79.06, the capacitor's is 1581.1, the reciprocals predict 75.2923 and the solved network measures 75.2923 — 2.2e-7% apart, by two routes that share only the element values. The resonance stays at 1/2π√(LC) to a part in a million throughout.

    The Q the components allow

    Resonance and its bandwidth measured a half-power width of exactly f₀/Q at every Q tried, for a circuit whose only resistance was the one deliberately put there. Real components arrive with resistance of their own, and the consequence is a ceiling rather than a penalty. The reciprocals of the component quality factors add, so the total sits below the smallest of them: an inductor of 79 beside a capacitor of 1 581 gives a resonator of 75. The worst component decides and the best one cannot help.

    part 3 · frequency
  3. A coil of 500 nF and a capacitor of 100 µH give the loop three features, not one. computed by solving, not by drawing. The current round the loop for a volt across it, with the coil carrying 500 nanofarads of its own capacitance and the capacitor 100 microhenries of its own inductance. Three features rather than one: the resonance the two nameplate values set, at 4.02 kHz; the coil's own self-resonance at 7.12 kHz, which is a parallel tank and so a null in a series loop, 5.67e+3 times below the peak beside it; and a second series resonance at 28.2 kHz that belongs to neither component. Above the null the coil is a capacitance, that capacitance is in series with the tuning capacitor, and the capacitor's own inductance resonates with the pair — which is why removing either parasitic removes this peak and neither alone can produce it.

    Two parasitics, and the resonance neither of them has

    A resonator's quality factor is supposed to sit below the worst of its components, because reciprocals add. Give the capacitor half a millihenry of its own inductance and the loop measures 92.21 against a coil that allows 64.55 and a reciprocal sum that predicts 62.47 — the ceiling passed exactly where ESL/L crosses ESR/DCR, at 5.00 per cent. Add the coil's own capacitance beside it and the loop grows a second resonance at 28.2 kHz that neither part has alone, taller than the first by 40.4, and the half-power level is then crossed four times.

    part 4 · frequency
  4. One series resonator of Q = 1, read five ways. computed by solving, not by drawing; every reading from the solved network, none from its formula. The half-power bandwidth, the phase slope at resonance and the energy ratio driven at resonance give 1.0000, 1.0000 and 1.0000 — Q exactly. The ring-down's logarithmic decrement gives 0.8660, and the largest capacitor-voltage magnification 1.1547.

    Five readings of one Q

    A resonator's Q can be read from its bandwidth, from the slope of its phase, from the energy it stores against the energy it loses, from how fast its ringing dies and from how high its response peaks. On one series resonator at Q = 1 the first three give 1.0000 and the last two 0.8660 and 1.1547. Bandwidth, phase slope and energy are Q exactly at every Q, because they are one equation read three ways; the ring-down reads Q√(1 − 1/4Q²) because a damped cycle is longer than a natural one, and the peak reads the reciprocal because the peak is not at resonance. Each is within 1% of Q only above 3.5.

    part 5 · frequency
  5. A tank with its loss in its coil, Q = 3: the voltage is largest at 0.9972 of 1/√(LC) and in phase with the current at 0.9428, and neither is where the poles sit. computed by solving, not by drawing, by closed form and by a netlist of L, Rs and C. The impedance of a coil of inductance L and series resistance Rs across a capacitor, against frequency, for Q = √(L/C)/Rs = 3. The poles are the series circuit's, at 1/√(LC) with a damping of Rs/2L. The coil's own zero at −Rs/L moves the peak to ωₘ = 0.9972·ω₀ and the zero-phase point to ωᵣ = 0.9428·ω₀, and the ring is at 0.9860·ω₀. Four frequencies, which a series circuit's voltage across its resistor would have as one.

    The reading a coil leaves nearly exact

    On a series resonator three readings of Q agreed exactly and two did not. A parallel tank whose loss is in its coil has no exact readings at all, and the order is not the one its schematic suggests. Its poles are the series circuit's, but the coil's own zero puts the peak, the zero-phase point and the ring at three different frequencies, and all of them below 1/√(LC). At Q = 3 the phase slope reads 16.2 per cent low, the stored energy 5.72 low and the peak height 5.42 high, while the bandwidth reads only 0.307 low: the loss that a parallel resistance stands in for tilts across the band, and the tilt is nearly antisymmetric about the centre, so the reading that spans it cancels it. The instrument's own source then decides what is being read.

    part 6 · frequency

All series