An exponential driven 10.0 mV either side of its bias
Drawn above at its default parameters, which is almost never how an essay calls it. A placement states the numbers that essay is arguing about, so the figure a reader meets is about that argument rather than about the generator — 98% of the placements on this site pass one, and the phase that raised that number from 12% found eight captions describing a figure the page was not showing.
At those defaults the edge it states is second harmonic 9.6% at 10.0 mV — the right-hand slot
of the caption strip, which on this site is never used for anything else, and which is read
back out of the drawing above rather than out of the code that wrote it.
It belongs to Devices, and where they stop being linear, which is to say a change to it is a
change to lib/figures/semi.js.
It takes a slider on drive amplitude (volts) with 7 settings,
and every one of them has passed the same assertions as the frame above — a figure whose
circuit stops doing what its caption says at any setting stops the build.
Called by 11 essays
which is the blast radius of changing it
The distortion a linear model cannot have
A small-signal model's output is a scaled copy of its input by construction, so it has no second harmonic and asking it for one is not a hard question but a meaningless one. Measured on the curve itself, an exponential produces one per cent of harmonic distortion at 1.03 mV of drive — seven times sooner than the 7.30 mV at which its gain is one per cent wrong.
What a pair cancels, and what it only halves
A differential pair's transfer characteristic is an odd function, and an odd function driven symmetrically produces no even harmonics at all. Measured, the second harmonic comes out at 10⁻¹⁶ of the fundamental — the arithmetic's own floor, not a small physical residue. The third harmonic is a different story, and it comes out at exactly half the single stage's, which is a reduction and not a cancellation.
What the limiter charges for
The diodes that set the amplitude are the only nonlinear thing in the loop, so every harmonic in the output is theirs. Across the gain slider the amplitude rises by a factor of 1.51 and the distortion by 15.4 — an amplitude that goes as the 0.11 power of the excess gain and a distortion that goes as the 0.74 power. Two diodes facing opposite ways produce no even harmonic at all, at seven parts in ten million, which is the arithmetic's floor rather than a small residue.
Two millivolts a kelvin, and the wrong sign
Every number in the semiconductor field was computed at 300 K, and the model had no temperature in it at all. Putting it in moves a diode's drop by 1.828 mV/K — downwards, although the thermal voltage in the exponent is rising, because the saturation current rises by nine orders of magnitude across the same range. Two temperature dependences of one device, of opposite sign, from one solve.
What a meter multiplies by
An average-responding meter rectifies, averages and multiplies by 1.1107, which makes it exactly right for a sinusoid and wrong for everything else by the ratio of two form factors — 11.07 per cent high on a square wave and 35.9 per cent low on a rectifier drawing its current in sixty degrees. It is also exactly right at one other waveform, a 145.90 degree conduction angle, which is nobody's sinusoid. Beside it a true-RMS meter that reaches nine harmonics is two per cent low on a square wave and never within one per cent of anything narrower.
What matching does about temperature
A pair cancels the 1.8 mV/K that broke the previous essay, and what it leaves behind is exact: a saturation-current mismatch of m shows up as an offset of the thermal voltage times ln(m), which is proportional to absolute temperature and therefore drifts in proportion to itself. 3 333 parts per million per kelvin, at every mismatch on the slider, because the ratio is 1/T and contains nothing about the device at all.
The capacitance that is not one number
A ten-microfarad ceramic at its rated five volts is 2.000 µF as a slope, 5.814 µF as a charge average and 2.105 µF as a bridge reads it — three answers to three different questions, all correct, all called the capacitance. At zero bias the standard one-volt test alone reads 5.2 per cent low. Marched in a circuit the same part distorts as the square of the drive with no bias and in proportion to it with a bias, because the bias is what puts a second harmonic there.
Where the two exponents come from
What a resistor in the emitter buys measured two exponents and could explain neither: the distortion edge moves as the square of the degeneration factor and the gain edge as its 0.950 power, and at a factor of exactly three halves the gain error vanished. The degenerated transfer curve has no closed form forwards and an exact one backwards, and reverting that series gives all three. The distortion exponent is exactly two; the gain edge is proportional to D squared over the root of the absolute value of three minus twice D, which is infinite at three halves and tends to a three-halves power; and the two edges are 7.07 apart on the bare device and 1.62 at a factor of eleven, against 7.06 and 1.61 measured.
The point the device is never at
A device's linearity is specified by one number, and that number is a place on no curve. The third-order intercept is where two straight lines would cross if both went on being straight, and neither does. For a differential pair the crossing sits π²/4 — 7.84 decibels — above the largest output the device can produce at any drive whatever, and the arithmetic that says so contains no tail current and no temperature.
What the fourth order says about the third
A closed form derived by neglecting the fourth-order term is a claim with an error, and the error is a quantity the fourth-order term can be asked about. Carried one order further, the degenerated exponential's reversion predicts 7.33 per cent where the leading expression was measured to be 6.89 per cent optimistic — and takes the residue to 0.362 per cent. The correction has its own edge, in the same quantity, and it is measured too.
The order that stops helping
Three essays in this field have derived expressions for the amplitude at which a degenerated stage's distortion reaches a target, each one order longer than the last, and each one nearer the measurement. This is where that stops. The error of an expression truncated at order m grows as the m-th power of the drive — 2.00, 4.00 and 5.88 measured — so every added order buys a range that ends sooner than the last one bought, and above 8.9 thermal voltages the six-term expression is further from the device than the four-term one.