The step at which the output impedance stops being a number
Drawn above at its default parameters, which is almost never how an essay calls it. A placement states the numbers that essay is arguing about, so the figure a reader meets is about that argument rather than about the generator — 98% of the placements on this site pass one, and the phase that raised that number from 12% found eight captions describing a figure the page was not showing.
At those defaults the edge it states is not a number above 11 mA — the right-hand slot
of the caption strip, which on this site is never used for anything else, and which is read
back out of the drawing above rather than out of the code that wrote it.
It belongs to Feedback, and the margin, which is to say a change to it is a
change to lib/figures/feedback.js.
It takes a slider on load capacitance (nF) with 5 settings,
and every one of them has passed the same assertions as the frame above — a figure whose
circuit stops doing what its caption says at any setting stops the build.
Called by 3 essays
which is the blast radius of changing it
The step too large to have an impedance
The rung below drove the load node with a current step and reported an impedance: a voltage divided by a current, which is a number only if the ratio does not depend on the current. Give the amplifier the differential pair's own tanh in place of a linear transconductor and it is a number up to 10.6 milliamps and not above — where the input error is 3.63 thermal voltages, and where the slew rate that decides it is twice the thermal voltage times the gain-bandwidth in radians, containing no design choice at all.
The current above which there is no impedance
The sixth rung found the impedance leaving at 10.6 mA, where the input pair's own tanh takes over and the slew rate is twice the thermal voltage times the gain-bandwidth in radians, with no design choice in it. A real output stage has a second limit that is nothing but design choice, and the two do not bind at the same load: at 0.47 nF the input pair's departure is 19.4 per cent against the output stage's 4.2, at 22 nF it is 0.9 against 2.3, and above the output stage's rating the excursion does not come back at all — 2,254 Ω for a quantity that was 37.
The load that neither limit owns
Nine rungs of this argument asked which of an amplifier's two large-signal limits binds, and drew the load capacitance where the answer changes hands. Both are present at every load: the excursion with both in the netlist is the two departures added and between 2 and 12 per cent more, never the larger of them. So the crossing is not a handover but a maximum — at 12 nanofarads the pair costs 2.084 times what the worse of them costs alone, against 1.35 at 2.2 nanofarads and 1.07 at 47 — and the same peak sits on the resistance axis at 20 ohms and the gain-bandwidth axis at 50 megahertz.