Three element voltages closing on one source, at 1.59 kHz
Drawn above at its default parameters, which is almost never how an essay calls it. A placement states the numbers that essay is arguing about, so the figure a reader meets is about that argument rather than about the generator — 98% of the placements on this site pass one, and the phase that raised that number from 12% found eight captions describing a figure the page was not showing.
At those defaults the edge it states is steady state only: 3 cycles to settle — the right-hand slot
of the caption strip, which on this site is never used for anything else, and which is read
back out of the drawing above rather than out of the code that wrote it.
It belongs to Frequency, which is the same solve, which is to say a change to it is a
change to lib/figures/frequency.js.
It takes a slider on frequency, as a multiple of resonance with 7 settings,
and every one of them has passed the same assertions as the frame above — a figure whose
circuit stops doing what its caption says at any setting stops the build.
Called by 6 essays
which is the blast radius of changing it
One solve, read four ways
Reactance, phase, the corner frequency and the roll-off are not four ideas. They are four readings of one complex number, obtained from the same matrix that answers direct-current questions — and the straight-line sketch every engineer draws of them is itself a model, three decibels wrong exactly where it is read.
The current that does no work
A solved network has been reporting its own real power on every page of this collection, as the second of the two checks each answer passes before it is drawn. What that check discards is the imaginary half — the power that flows out to a reactance and back again, does nothing, and is still carried by the cable, still heats the transformer, and is still on the bill.
Three voltages that close on one, and the steady state they assume
Kirchhoff's voltage law drawn as a polygon in the complex plane. The three element voltages of a series circuit add head to tail to the source exactly — while their magnitudes add to five times it. And the whole picture is a statement about a settled circuit, which takes a computable number of cycles to arrive.
Three phases, and the wire that carries nothing
Three sources a third of a cycle apart, feeding three equal loads, return a current of 5×10⁻¹⁵ amperes down the wire between the star points. That is zero, and the whole of three-phase distribution rests on it. What is worth measuring is how fast it stops being zero, and the answer is that an eleven per cent imbalance in one phase puts a tenth of a line current down a conductor often sized on the assumption that it carries none.
The arrow that goes past where it settles
A phasor is where a driven resonator ends up, and counting the cycles it takes to get there says nothing about the path. Switched on from rest a little away from resonance, the capacitor's arrow circles its settled tip instead of approaching it: a Q of 50 driven at 0.8 of resonance reaches 1.854 times its settled voltage, and a Q of 200 at 1.25 switched on through zero reaches 2.182. At resonance exactly, where the settled voltage is largest, the arrow never passes its mark. So a resonance read by the largest voltage after switch-on is 1.20 times wider than its phasor says.
How long a sweep waits at each step
A resonance measured by a stepped sweep that starts each frequency from rest and reads the last cycle of its wait comes out 19.6 per cent too wide after Q cycles a step, and within one per cent of its width only from 1.65Q cycles at a Q of ten and 1.60Q at fifty. That is longer than the 1.47Q the transient takes to fall to a per cent, and the reason is the centre rather than the skirts: the width's error is the peak's shortfall read twice, while at the half-power frequencies the transient swings through its settled value and partly cancels itself. A reading that holds its peak instead is twenty per cent wide however long it waits.