Circuit Response
every model has an edge, and the figure carries it
Series

Reflections — the series

4 essays on one idea, from the one that introduces it to the one that assumes the rest.
  1. A 1 V step onto 1.00 m of 50 Ω line into an open circuit. computed by solving, not by drawing as a sum of 81 arrivals. The source drives 0.8333 V into the line immediately — set by 10 Ω against the line's 50 Ω, and not by the load, which it cannot yet know about. One delay of 4.83 ns later the far end reaches 1.6666 V. The staircase settles at 0.999990 V, which is what the resistive divider gives.

    The staircase in time

    A source driving a metre of cable does not know what is on the far end of it for 4.83 nanoseconds. What it drives into during that time is decided by the cable's characteristic impedance and nothing else — and when the far end finally answers, the answer comes back as a staircase whose limit is the resistive divider the circuit was going to be all along.

    part 1 · lines
  2. 1 pF across a 50 Ω line: a dip of 0.320 V and an area of 25 ps. computed by solving, not by drawing as a cascade of two-ports, with a raised-cosine edge of 59 ps sent into it. The incident edge is the faint curve; what comes back is the shaded dip and what goes on is the third. The dip reaches -0.3202 V and its area is 25 ps, which is Z₀C/2 to a part in ten thousand. Driven by an edge fifty times faster the same cascade returns the single exponential the closed form gives, to 9.3e-6 of a volt. The transmitted edge leaves at 81.1 ps, against 59 ps arriving.

    The dip whose area is fixed

    A picofarad across a 50 Ω line makes a dip in what comes back. Its depth is 0.833 volts to a six-picosecond edge and 0.0196 volts to a nanosecond one, forty-two times less; its area is 25 picoseconds to both, to six parts in a hundred thousand, because the area is Z₀C/2 and contains nothing about the edge. Two half-picofarad discontinuities too close to tell apart read as exactly one picofarad, and so do two far enough apart to be separate — the area is additive where the depth is not. And what a reflectometer calls the capacitance of an impedance step is the step's real excess capacitance times 1 + Z/Z₀.

    part 2 · lines
  3. A via's area changes sign at 44.7 Ω, and two impedances give its 0.5 pF and 1 nH back. computed by solving, not by drawing, as a cascade of two-ports: a via of 0.25 pF, 1 nH and 0.25 pF, met by an edge of 59 ps from reference lines of 20 to 150 Ω. The area under the reflection is −Z₀C/2 + L/2Z₀ at every impedance: a bump below 44.7 Ω, where the inductance's term is the larger, nothing at it, and a dip above. From 50 Ω the area is 2.5 ps of dip, which a single-capacitance reading calls 0.100 pF. From 50 and 75 Ω together the two areas give 0.5000 pF and 1.0000 nH. An error of 50 fs on each area moves them by up to 0.8% and 1.5%.

    The via two lines can weigh

    The area under a reflection is a property of the discontinuity rather than of the edge, and for a via it is one number made of two: −Z₀C/2 from its pads and +L/2Z₀ from its barrel, with opposite signs. A via of half a picofarad and a nanohenry, seen from fifty ohms, leaves 2.5 picoseconds of dip — which a reading that assumes a capacitor calls 0.100 pF, a fifth of what is there. From fifty and seventy-five ohms together the two areas give 0.5000 pF and 1.0000 nH back, and fifty femtoseconds of error on each costs 0.8 per cent of the capacitance and 1.5 of the inductance. A second line at fifty-five ohms costs five times as much.

    part 3 · lines
  4. At 44.7 Ω the via's area is zero; its reflection is a doublet falling as the 1.99 power of the edge, not the first. computed by solving, not by drawing, as a cascade. A via of 0.25 pF, 1 nH and 0.25 pF on a line of √(L/C) = 44.72 Ω, met by an edge of 59 ps, against the same capacitance alone on the same line. The via's reflection is a doublet — a dip and a bump of equal area — whose largest excursion is 24.4 mV against 166 mV for the capacitance alone. Over edges from 5.9 ps to 295 ps the capacitance's reflection falls as the −0.97 power of the edge and the via's as the −1.99 power: 24.4 mV at 59 ps, 994 µV at 295 ps. The via delays the edge going past it by 22.4 ps, against √(LC) = 22.4 ps.

    The via that is a piece of line

    A via of half a picofarad of pad and a nanohenry of barrel puts no area under its reflection from a line of √(L/C) = 44.72 ohms, from any edge. It has not vanished. It delays the edge going past it by 22.4 picoseconds, which is √(LC) exactly, and it still reflects: a doublet whose largest excursion falls as the −1.99 power of the edge where a lone capacitance's falls as the −0.97 — 24.4 millivolts for a 59-picosecond edge against 166 for the pads alone, and 994 microvolts for a 295-picosecond one against 35. The balanced via is a short piece of line, and the reflection it leaves is the reflection of its length rather than of its size.

    part 4 · lines

All series