Circuit Response
every model has an edge, and the figure carries it
Concept

Current density — where it appears

Current per unit of cross-sectional area, in amperes per square metre, at a point in a conductor. Resistance and heating are decided by where it concentrates rather than by the total current, so skin effect, proximity and a return path's spread are all statements about it.

Named by 2 essays across one field — each of them below, with the objects they name alongside it.

A track needs about three heights of copper beside it, and it is the resistance that says so. computed by solving, not by drawing at 100 MHz, each point a strip solve of its own on a 50 mm plane of the same area, moved sideways. The horizontal axis is where the track's centre sits relative to the plane's edge, in units of the track's height above it; negative is a track hanging past the edge with no copper beneath it. With the centre directly over the edge the loop's inductance is 1.161 times its centred value and its resistance 2.90 times, because the return has to crowd into the last few hundred micrometres of copper. Three heights in, the inductance is 1.006 times and the resistance 1.09; ten heights in, both are within 0.7 per cent. Three heights past the edge the inductance is 1.82 times. At direct current every point on this axis is exactly one, because the copper has been moved and not removed.

Where the plane runs out

The corner that is three decades wide solved a return current over a plane that extends well past the track on both sides. Where it does not, the two costs arrive at opposite ends of the band: at direct current a plane that ends under the track costs 27 per cent of inductance and not one part in a million of resistance, and above the band it costs 16 per cent of inductance and 199 per cent of resistance. Three track-heights of copper beside the track removes almost all of both, and the number three has no millimetres in it — sixteen times the whole cross-section gives the same ratios to a part in a billion.

lines · Return path Two tracks 1 mm apart share all of the plane's resistance at direct current and 14.5% of it above the band. computed by solving, not by drawing, across a 50 mm plane cut into 239 strips, with two tracks 200 µm above it and 1 mm apart — 5.0 heights. One track carries the current and the voltage along the other's loop is measured. The shared resistance, as a fraction of the driven loop's own, is 1 at direct current, where both returns spread across the whole plane and share its 10 mΩ/m; it falls through a half at 183 kHz and settles at 0.1454 above 10.0 MHz, where each return has gathered under its own track. The shared inductance is 0.398 of the loop's own at direct current and 0.0341 above the band.

Two returns in one plane

Two tracks over one plane share the whole of its resistance at direct current, however far apart they are routed: 10 milliohms a metre on a fifty-millimetre plane, from tracks a millimetre apart or ten. The sharing ends across the same band a single return gathers over, and it ends sooner the farther apart the tracks are — through a half at 525 kilohertz for tracks three heights apart and at 9.88 kilohertz for fifty. Above the band what is left is the overlap of two image distributions, 4h²/(4h² + d²): 14.5 per cent of the resistance at a millimetre, 0.68 at five. And in the middle of the band the two loops' mutual inductance changes sign.

lines · Return path

Named alongside it

The objects these essays reach for when they reach for this one.

Loop areaModel rangeParasiticsReturn currentSkin effectCrosstalkVerification

All concepts