Concept

Transit frequency — where it appears

The frequency at which a transistor's current gain falls to one, which bounds every quantity that depends on that gain. It is an upper bound rather than a working figure, since the Miller multiplication puts a stage's own bandwidth far below it.

Named by 3 essays across one field — each of them below, with the objects they name alongside it.

A common-emitter stage with 2.0 pF from collector to base. computed by solving, not by drawing. The stage's midband gain is 144.7 and its −3 dB point is at 504 kHz. The Miller approximation lumps 311 pF at the input and predicts 643 kHz — 21.6% high. The network's second pole is at 336 MHz and its right-half-plane zero at 3.08 GHz, both of which the approximation has no room for.

The frequency a device sets for itself

A common-emitter stage's bandwidth is decided by two picofarads between its collector and its base. The Miller approximation says how — lump it at the input, multiplied by one plus the gain — and predicts 643 kHz where the solved network gives 504 kHz. Twenty-two per cent optimistic, and it has no room at all for the second pole or for the zero in the right half-plane that the network also has.

semiconductors · Device bandwidth

A follower's output impedance from 1 kΩ of source, bare and with 100 pF on it. computed by solving, not by drawing, on a small-signal follower at 2.0 mA with β = 150 and fT = 560 MHz. At 100 Hz the emitter presents 19.08 Ω against a textbook 1/gₘ + Rₛ/(β+1) of 19.55 Ω — the expression is an upper bound here and at every source resistance on the slider, 2.4% high at this one. What it cannot describe is the frequency axis: the β that divided the source resistance down is itself falling, so the impedance rises, and the reactance at 3 MHz is 4.3 Ω — an inductance of 0.229 µH against Rₛ/ωT = 0.284 µH. With 100 pF hung on the output that impedance peaks at 67.0 Ω at 29.3 MHz, 3.51 times its own low-frequency value: an inductive source and a capacitive load are a resonant circuit, and this one is inside a part whose output impedance is quoted as a single number.

The buffer that is not a buffer

An emitter follower is reached for when something has to be driven without being loaded: unity gain in, high impedance seen, low impedance presented. The last of those is a number with a range, and the range is narrow. At a kilohm of source the emitter presents 19.08 ohms at low frequency and 67 ohms at 29 megahertz, because the current gain that made it small is falling — and the peak is worst in the middle of the slider, so it cannot be avoided by making the source stiffer or softer.

semiconductors · Emitter follower

A follower with 1000 pF on it looks like -1182 Ω of negative resistance. computed by solving, not by drawing. The impedance looking into the base of an emitter follower carrying 5.0 mA, with 1000 pF on its emitter. The real part is negative from 1.25 MHz upward and reaches -1182 Ω at 3.40 MHz: the load's reactance multiplied by a complex current gain, with nothing added to the model. A negative resistance is not an oscillator until a reactance cancels, and the base lead supplies it — the total loop reactance passes through zero at a frequency the inductance chooses, and the loop resistance there goes negative above 74.9 nH with 10 Ω of source, which is a few centimetres of wire. A hundred ohms of source raises that to 913 nH: the repair is a resistor in the base, and it works by making the source worse.

The input that pushes back

An emitter follower with a capacitor on its emitter has a negative resistance looking into its base — 1182 ohms of it at 3.4 megahertz for a nanofarad, with nothing added to the model. A negative resistance is not an oscillator until a reactance cancels, and the base lead supplies it: with ten ohms of source the loop goes unstable above 74.9 nanohenries, which is seven centimetres of wire. The repair is the opposite of the instinct — a hundred ohms of source raises the threshold to 913 nanohenries, so the fix for a follower that oscillates is to make the thing driving it worse.

semiconductors · Emitter follower

Named alongside it

The objects these essays reach for when they reach for this one.

Emitter follower Capacitive load Current mirror Dominant pole Dynamic resistance Gain–bandwidth product Input capacitance Lead inductance Loading Miller effect Model range Output impedance

All concepts