The switches set the floor below 60.2 MHz and the amplifier sets it above
Drawn above at its default parameters, which is almost never how an essay calls it. A placement states the numbers that essay is arguing about, so the figure a reader meets is about that argument rather than about the generator — 98% of the placements on this site pass one, and the phase that raised that number from 12% found eight captions describing a figure the page was not showing.
At those defaults the edge it states is the floor changes hands at 60.2 MHz — the right-hand slot
of the caption strip, which on this site is never used for anything else, and which is read
back out of the drawing above rather than out of the code that wrote it.
It belongs to The floor, and what is under it, which is to say a change to it is a
change to lib/figures/noise.js.
It takes a slider on hold capacitor (pF) with 7 settings,
and every one of them has passed the same assertions as the frame above — a figure whose
circuit stops doing what its caption says at any setting stops the build.
Called by 6 essays
which is the blast radius of changing it
The noise a clock does not make
A hundred-megohm resistor has a noise density of 1.27 microvolts per root hertz. A switched capacitor that behaves as a hundred megohms has none of it: the noise on the capacitor it charges is kT/C, with the holding capacitor in it and nothing else — not the clock, not the switched capacitor, not the on-resistance. And it is exact rather than asymptotic, at every capacitor ratio from a thousandth to ten.
The amplifier inside the sample
kT/C is exactly independent of the clock, of the capacitor ratio and of the switch resistance — two essays measured that and found it identically true rather than nearly so. The amplifier in the same loop behaves in the opposite way in every respect: its noise is white, it is sampled, and the number of times it folds into the band is exactly the number of time constants the settling needs. So the switches set the floor below sixty megahertz and the amplifier sets it above, and asking for two more bits of settling costs fifteen per cent more noise before anything else has changed.
The sample that is subtracted
Three earlier measurements found floors that no gain moves and no filter reaches, because both arrive as numbers already sampled. One of them can be subtracted: the reset level a capacitor holds is the same number in two consecutive samples and cancels exactly. What it costs is that the amplifier's own noise is not — two samples of it are independent, so its variance doubles. That is thirty times better at a megahertz, a loss above sixty, and the crossing is the one an earlier essay computed for a different question.
The average that is not N times quieter
Averaging sixteen samples of a 1 pF capacitor is supposed to take its 63.3 µV of kT/C noise down by four. With one RC of tracking between samples it takes it down by 2.8: the switch has not been closed long enough for the capacitor to forget the last sample, each shares 37 per cent of its value with the one before, and sixteen samples are worth 7.8 independent ones. At a quarter of an RC they are worth 2.6. Sampling faster never helps past a ceiling: however quickly the samples come, an average gathers at most one independent sample per 2RC of time — the continuous average's own limit. And a sampler that settles its signal to 8 bits has already waited long enough for its noise.
The average an integrator can hold
A switched-capacitor integrator is an averager whose samples are exactly independent, because every cycle resets the sampling capacitor — and it pays for that with two switch phases, 2kT/Cs a cycle, 89.5 µV rms with a picofarad. An ideal integrator averages that as 1/√N without end. A real one leaks through its amplifier's finite gain, and the leak caps the average at 2A·Cf/Cs cycles: 8,000 for a gain of a thousand and a 4 pF feedback capacitor, where the noise stops at √(kT/(A·Cf)) = 1.00 µV. That floor contains the feedback capacitor and the gain and not the sampling capacitor at all, which decides only how long the integration takes to reach it.
The leak worth building in
An integrator that never forgets cannot follow an input that moves. Give a switched-capacitor integrator a deliberate leak — a damping capacitor that samples the output each cycle and takes its charge away — and it becomes an exponential average with a memory of Cf/Cd cycles. Fed an input drifting 1 µV a cycle, through a 1 pF sampling capacitor, too short a memory passes the switch noise and too long a memory lags the drift; the best, on the exact closed form and on seeded marches of sixty thousand cycles, is 16.5 cycles, for 27.2 µV of error against 89.5 µV in a single sample. The best memory follows a cube-root law, the cube root of kT/(Cs·r²), ten times the drift for a memory 4.64 times shorter, and at it the noise variance is twice the squared lag. And the leak is not free: the damping capacitor is switched too, and at unity gain it samples half of the averager's noise.