Concept

Amplitude stabilisation — where it appears

The mechanism that decides how large an oscillation settles, by reducing the loop gain as the amplitude rises until the average round the loop is one. Without one the linear design fixes only the frequency, and the amplitude either grows until something clips or dies away.

Named by 3 essays across one field — each of them below, with the objects they name alongside it.

Started from a millivolt at a gain of 3.20. The output grows by 1.8804 a cycle — the factor the poles give — and then stops, at 858 mV of amplitude and 1.58 kHz. The lower panel is the envelope on a logarithmic axis, where the linear model's prediction is the straight line that keeps going. What ends it is the diode pair across the feedback resistor, and no direct-current analysis of this circuit returns that number.

The amplitude nothing linear predicts

A linear model's poles say the envelope grows by 1.88 a cycle and never say when it stops. Two diodes across the feedback resistor stop it, at 858 millivolts — a number no pole, no transfer function and no bias point contains. Getting it needs a netlist with a nonlinearity in it, marched forward in time, and that pairing is what the whole field is built on.

applied · Oscillator

The limit cycle's spectrum at a gain of 3.20. Ten lines of the settled waveform. The third is 5.692% of the fundamental and the fifth 0.982%; the second and fourth are 6.8e-7, which is the arithmetic's floor and not a small residue. Two diodes facing opposite ways make a symmetric characteristic and a symmetric characteristic produces no even harmonic at all.

What the limiter charges for

The diodes that set the amplitude are the only nonlinear thing in the loop, so every harmonic in the output is theirs. Across the gain slider the amplitude rises by a factor of 1.51 and the distortion by 15.4 — an amplitude that goes as the 0.11 power of the excess gain and a distortion that goes as the 0.74 power. Two diodes facing opposite ways produce no even harmonic at all, at seven parts in ten million, which is the arithmetic's floor rather than a small residue.

applied · Oscillator

The growth per cycle, and the form that is a fifth low at the top of the range. computed by solving, not by drawing. The factor the envelope is multiplied by each cycle, against the gain. The solid curve is exp(π(k−3)/√(1 − ((k−3)/2)²)), which is what the characteristic equation gives and what the netlist's own poles return to twelve digits; the dashed one is exp(π(k−3)), which drops the denominator. The circles are the marched envelope, fitted over the cycles that are still small — 80 of them at k = 3.01 and 4 at k = 3.2, and none at all above that. The two expressions differ by 3.9e-7 at k = 3.01 and by 20.462% at k = 3.8, so the approximation fails exactly where nothing is left to check it against.

Two exponentials, and where they meet

An oscillator's envelope grows by exp(π(k−3)/√(1 − ((k−3)/2)²)) a cycle, and the form usually quoted drops the denominator — exact to four parts in ten million at a hundredth above three, and 20.462 per cent low at 3.8, which is precisely where too few small cycles are left to measure it. Where the growth stops is the diode's own exponential: 108.5 millivolts of amplitude for every decade of saturation current, proportional to the ideality to four parts in a thousand. Above 60.121 nanoamperes the limiter is already conducting at zero signal and there is no oscillation at all.

applied · Oscillator

Named alongside it

The objects these essays reach for when they reach for this one.

Limit cycle Design tradeoff Companion model Ideality factor Model range Newton raphson Nonlinearity Odd symmetry Poles Power law fit Saturation current Settling time

All concepts