Circuit Response
every model has an edge, and the figure carries it
Concept

Linear range — where it appears

The span of drive over which a device's response is proportional to it within a stated fraction, which is a different number for distortion and for gain error. It is a different number for each quantity measured: distortion arrives seven times sooner than gain error on an exponential device.

Named by 3 essays across 3 fields — each of them below, with the objects they name alongside it.

The ideal amplifier is good to 1% over a region, and its corner is 21% inside the specifications. computed by solving, not by drawing. The 1 per cent contour of the ideal-amplifier model for a non-inverting stage of gain 2 built from a 10 MHz part, drawn over frequency and output amplitude at once. Each point is bisected on a marched circuit: the error is the root-mean-square difference between the marched output and 2 times the input, which counts the gain that is low, the phase that is late and the peak that is flat. Three mechanisms bound the region — finite gain–bandwidth on the left, the input pair's slew rate on the diagonal, and the rails at 12.19 V along the top. The two dashed lines are the numbers a data sheet gives: a small-signal edge at 48.8 kHz with no amplitude in it, and a full-power bandwidth of slew rate over 2πV̂ with no gain–bandwidth in it. They cross at 10.60 V and 48.8 kHz; the measured contour passes 38.5 kHz at that amplitude, which is 0.790 of it.

The edge that is a region

Every boundary this collection has drawn is a number on one axis, and the figure that gathers four of them admits in its own caption that the fifth is an amplitude and cannot go there. Drawn on both axes at once, the ideal amplifier's one per cent boundary is a region with three sides and a corner — and the corner sits at 38.5 kilohertz where the two numbers a data sheet quotes cross at 48.8, because the two mechanisms are lags on the same waveform and add as magnitudes rather than in quadrature.

limits · Model edges An exponential with 6× of degeneration: both edges move, and not together. computed by solving, not by drawing at 61 amplitudes. Total harmonic distortion reaches one per cent at 36.6 mV and the gain falls one per cent short of its small-signal value at 85.0 mV. An emitter resistor dividing the gain by 6 moves the distortion edge by 35.4 times — the square of the factor, because the resistor both divides the drive reaching the junction and linearises what the junction does with it — while the gain edge moves by only 11.6 times. So the two edges close up: 2.32 times apart here against 7.06 bare, and a well-degenerated stage stops being limited by its linearity and starts being limited by how accurately its gain is known.

What a resistor in the emitter buys

Degeneration is described as a trade: give up gain, get linearity. Measured on the transfer curve, the two sides of that trade are not the same size. Dividing the gain by six moves the amplitude at which distortion reaches one per cent by thirty-five times — the square of the factor — and the amplitude at which the gain is one per cent out by only twelve. So the two edges close up, and a well-degenerated stage stops being limited by its linearity and starts being limited by how accurately its gain is known.

semiconductors · Emitter degeneration A 350 Ω bridge, with ideal leads. The straight line is the expression every textbook gives, Vδ/4; the curve is the solve. They part company at half the fractional change — 0.498% at 1.0% — so the tangent is worth one per cent only up to 2.020%. Driving the bridge from a current source instead halves the departure at every point and moves that edge to 4.040%.

The bridge that is linear near one point

The expression for a Wheatstone bridge's output is V delta over four, and the solve says it is V delta over two times two plus delta — low by half the fractional change, exactly, at every change tested. So the tangent is worth one per cent only up to a two per cent change and a tenth of a per cent only up to two tenths. Driving the bridge from a current source instead halves the departure at every point and doubles both edges, which is a change of one component and no change at all to the four resistors being measured.

applied · Bridge

Named alongside it

The objects these essays reach for when they reach for this one.

Design tradeoffDevice matchingEmitter degenerationExcitationGain–bandwidth productGain compressionLarge-signalLead resistanceLocal feedbackModel rangeModel refusalSlew rate

All concepts