Circuit Response
every model has an edge, and the figure carries it
Concept

Local feedback — where it appears

Feedback applied around a single device rather than around a whole amplifier, trading its gain for linearity and predictability in the same ratio. A resistor in an emitter is the simplest kind, and what it buys is measured in the exponent of the distortion rather than in the gain alone.

Named by 3 essays across 2 fields — each of them below, with the objects they name alongside it.

An exponential with 6× of degeneration: both edges move, and not together. computed by solving, not by drawing at 61 amplitudes. Total harmonic distortion reaches one per cent at 36.6 mV and the gain falls one per cent short of its small-signal value at 85.0 mV. An emitter resistor dividing the gain by 6 moves the distortion edge by 35.4 times — the square of the factor, because the resistor both divides the drive reaching the junction and linearises what the junction does with it — while the gain edge moves by only 11.6 times. So the two edges close up: 2.32 times apart here against 7.06 bare, and a well-degenerated stage stops being limited by its linearity and starts being limited by how accurately its gain is known.

What a resistor in the emitter buys

Degeneration is described as a trade: give up gain, get linearity. Measured on the transfer curve, the two sides of that trade are not the same size. Dividing the gain by six moves the amplitude at which distortion reaches one per cent by thirty-five times — the square of the factor — and the amplitude at which the gain is one per cent out by only twelve. So the two edges close up, and a well-degenerated stage stops being limited by its linearity and starts being limited by how accurately its gain is known.

semiconductors · Emitter degeneration An exponential with 6× of degeneration: both edges move, and not together. computed by solving, not by drawing at 61 amplitudes. Total harmonic distortion reaches one per cent at 36.6 mV and the gain falls one per cent short of its small-signal value at 85.0 mV. An emitter resistor dividing the gain by 6 moves the distortion edge by 35.4 times — the square of the factor, because the resistor both divides the drive reaching the junction and linearises what the junction does with it — while the gain edge moves by only 11.6 times. So the two edges close up: 2.32 times apart here against 7.06 bare, and a well-degenerated stage stops being limited by its linearity and starts being limited by how accurately its gain is known.

Where the two exponents come from

What a resistor in the emitter buys measured two exponents and could explain neither: the distortion edge moves as the square of the degeneration factor and the gain edge as its 0.950 power, and at a factor of exactly three halves the gain error vanished. The degenerated transfer curve has no closed form forwards and an exact one backwards, and reverting that series gives all three. The distortion exponent is exactly two; the gain edge is proportional to D squared over the root of the absolute value of three minus twice D, which is infinite at three halves and tends to a three-halves power; and the two edges are 7.07 apart on the bare device and 1.62 at a factor of eleven, against 7.06 and 1.61 measured.

semiconductors · Emitter degeneration A junction and its resistor in one loop: equal shares at 12.50 mV, and quietest against both at 49.98 mV. computed by solving, not by drawing. A junction carrying 25 µA in series with a resistor, the loop closed into a short and solved as a netlist with each noise current injected across its own element. Against the drop across the resistor: the bare junction's 2qI, the bare resistor's 4kT/R, each one's share of what reaches the outside, and the total. The shares are equal at 12.50 mV (500 Ω), not at the 49.98 mV where the bare floors cross; there the resistor supplies 80.0 per cent and the total is 0.5556 of either floor. The total is below both floors at every drop.

The resistor in the same loop

A resistor's noise and a junction's are equal as bare densities at 49.98 millivolts of drop, and a junction in series with the resistor that carries its current is the arrangement every current source is built from. In one loop each noise current has to cross the other element, so the two supply equal shares at 12.50 millivolts, a quarter of the crossing; at the crossing itself the resistor supplies 80 per cent and the loop is 2.553 decibels below both floors, which is further than it gets anywhere else. The same resistor multiplies the stage's input-referred noise by five.

noise · Shot noise

Named alongside it

The objects these essays reach for when they reach for this one.

Emitter degenerationGain compressionTotal harmonic distortionTransconductanceTransfer curveCurrent mirrorCurrent noiseDevice matchingDynamic resistanceEven harmonic cancellationJohnson noiseLinear range

All concepts