Circuit Response
every model has an edge, and the figure carries it
Concept

Oscillation — where it appears

Oscillation is a periodic output produced with no periodic input, sustained because a loop's net loss at some frequency is negative. It is predicted from an impedance whose real part changes sign, or from a loop gain that reaches one with no phase margin left, rather than waited for on a bench.

Named by 5 essays across 4 fields — each of them below, with the objects they name alongside it.

A follower fed through 100 nH has an output resistance of -21.9 Ω. computed by solving, not by drawing. The real part of the impedance looking into the emitter, driven by a current source and read, at every frequency. At direct current it is 5.50 ohms, which is the same rₛ/(β+1) + 1/gₘ the follower's first essay computed. Between 110 MHz and 301 MHz it is negative: rπ and Cπ delay the current the transistor sources into the emitter, and past a quarter of a cycle of delay pushing the emitter up makes the device push it up as well. The dashed curve is the same follower with no inductance between the source and the base, and it never goes below zero — the sign belongs to the wire and the transistor together, and to neither alone.

The resistance that is below zero

An emitter follower's output resistance is 5.5 Ω at direct current and −21.9 Ω at 257 MHz, and the sign is not the transistor's: with an ideal source at the base there is no negative band at all, and a hundred nanohenries of wire between the source and the base produces one from 110 to 301 MHz. A capacitance resonating inside that band is a resonator with loss of the wrong sign, so 4.7 to 100 pF on the emitter oscillates while 1 pF and 470 pF do not — a band of load capacitance with quiet ground on both sides of it.

semiconductors · Emitter follower The sign change follows the 0.51 power of the amplifier, not the inductor. computed by solving, not by drawing. Both of the arrangement's frequency boundaries against the gain–bandwidth of the two amplifiers in it, over three decades. The lower curve is the frequency at which the series resistance changes sign, bisected on the sign of the real part; the upper one is where the inductance leaves one per cent. The crossing grows as the 0.513 power of the gain–bandwidth, and the dashed prediction over it is ½√(fc·fₚ) — half the geometric mean of the arrangement's own corner r/2πL = 1.59 kHz and the amplifier's open-loop pole f_t/A₀ — which is inside one per cent while that pole is at least fifteen times below the corner and 8.7 per cent out at the top of the sweep, where it is not. The two boundaries stay between 1.61 and 2.30 per cent of one another throughout, so a faster amplifier moves the active region rather than removing it.

The boundary that improves when the part gets worse

A synthetic inductor's series resistance changes sign at 63.0 Hz with one-megahertz amplifiers, and that frequency is not a property of the inductor. It is half the geometric mean of the arrangement's own corner and the amplifier's open-loop pole — half the square root of their product, which the bisection confirms to a part in a thousand — and it therefore falls as the amplifier's direct-current gain rises, from 686 Hz at a gain of a thousand to 19.9 Hz at a million. The quantity that decides whether a resonator starts does not move at all: it is the transition frequency over four times the Q, 2.50 kHz for a tank of a hundred.

filters · Gyrator A guarded input driven through an inductance oscillates once the source's L/R passes 1/ωₜ. computed by solving, not by drawing. The real part of the rightmost natural frequency of a guarded input — a 100 pF cable bootstrapped by a 1.00 MHz follower, 10 pF of input capacitance — driven from sources of 10 Ω, 100 Ω, 1 kΩ with an inductance in series, against the inductance. Above zero the input rings with growing amplitude. Each source crosses at 1.75 µH, 17.6 µH, 187 µH, close to R/ωₜ — 1.59, 15.9, 159 µH — and oscillates at 11.4 MHz, 3.59 MHz, 1.14 MHz. The same source without the guard is stable.

The source that rings against its guard

A bootstrapped cable is a capacitance in series with a negative resistance that falls as the square of frequency, −1/(ω²·C/ωₜ). Drive it from a source with resistance R and inductance L and the loop's reactances cancel at 1/√(LC). Its resistances cancel where R = L·ωₜ, so the input oscillates once the source's own time constant L/R passes the follower's 1/ωₜ. The poles of the whole netlist say 17.6 µH for a 100 Ω source behind a 1 MHz follower, against 15.9 from the expression. The cable's length moves that by at most a factor of two and sets only the frequency it rings at. The same source without the guard is stable. A resistor in the guard drive raises the limit, to 164 µH through 1 kΩ, and pays for it in bootstrap bandwidth.

instruments · Guarding A second pole at 3.00 MHz makes a 9.49 Ω source 4.1 times safer and a 949 Ω one 20% less safe. computed by solving, not by drawing. The source inductance above which a guarded input oscillates — a 100 pF cable bootstrapped by a 1.00 MHz follower with 10 pF of input capacitance — bisected on the sign of the rightmost pole of the whole netlist, against the source resistance, for a follower with no second pole and with one at 30 MHz, 3 MHz and 1.5 MHz; the thin line is R/ωₜ. With a second pole at 3.00 MHz the critical inductance is 6.85 µH at 9.49 Ω against 1.66 with one pole, and 141 µH at 949 Ω against 177: a low-resistance source rings high above the follower's crossover, where the second pole takes gain away, and a high-resistance one rings near it, where the pole adds phase.

The second pole the ringing guard sees

A guarded input driven through an inductive source oscillates once L/R passes 1/ωₜ — for a follower with one pole. Give the follower the second pole every real amplifier has and the rule stops being a bound in either direction. A 9.49 Ω source that rang above 1.66 µH now needs 6.85 µH with a second pole at 3 MHz, four times safer; a 949 Ω source that rang above 177 µH now rings above 141, a fifth worse. The dividing line is the frequency the input rings at: above the geometric mean of the follower's crossover and its second pole, the pole takes gain from the bootstrap and helps; below it the pole adds phase and hurts. On three poles a decade apart the change of sign falls within 2.4 per cent of √(fₜ·f₂).

instruments · Guarding The bootstrap with 1 nF at its node: one natural frequency, against the gain. computed by solving, not by drawing: the natural frequency of the network found as the root of its determinant at each of 31 gains. It is −G/C to a part in a million at every gain, where G is the Thévenin conductance the reduction gives: −200 thousand per second at A = 0, zero at A = 2 where the resistance passes through infinity, and +100 thousand at A = 3 — a growth rather than a decay. The gain at which the pole crosses into the right half-plane is the gain at which the resistance changes sign, and the capacitor's size moves the pole's speed and nothing else.

The pole that crosses with the resistance

A bootstrap's Thévenin resistance passes through infinity and turns negative at a gain of two. Put one nanofarad at its node and the network has one natural frequency, −G/C to a part in a million: −200 thousand per second with no gain, zero at A = 2, +100 thousand at A = 3. The gain at which the pole crosses is the gain at which the resistance changes sign — for this network. Loaded by a resistor it crosses at one plus R₂ times the sum of the conductances to ground, so a negative resistance is stable across a smaller load and not a larger one; a lag in the source slows the growth and does not move the crossing; a tank on the node turns the runaway into a 30.5 kHz oscillation once its coil is below about 1.5 Ω; and with an inverting source the resistance is positive at every gain and the node still oscillates beyond A = −16.

networks · Equivalent circuit

Named alongside it

The objects these essays reach for when they reach for this one.

Negative resistanceBootstrappingPolesStabilityGain–bandwidth productGuardingModel rangeEmitter followerGyratorHybrid piLoop gainNullor

All concepts