Circuit Response
every model has an edge, and the figure carries it
Concept

Rectifier — where it appears

A network of diodes that lets current into a reservoir capacitor only while the supply exceeds what the capacitor already holds. Its current is therefore a train of short pulses rather than a sinusoid, with a root-mean-square value well above its mean, and a displacement factor of one alongside a true power factor near 0.6.

Named by 2 essays across one field — each of them below, with the objects they name alongside it.

The first conduction carries 26× the repetitive peak, and the factor of 7 is the user's. computed by solving, not by drawing. The largest diode current in the first conduction after switch-on, against the phase of the mains at the instant of switching, marched from an empty capacitor through the same netlist the ripple and the conduction angle are read from. The settled circuit's largest current is 1.230 A; the first one is 32.39 A at the worst instant and 4.64 A at the best, so which of them a design has to survive is decided by nothing in the design. The estimate that treats the capacitor as a short circuit gives 34.00 A, 4.7% high, the difference being the charge the capacitor takes during the pulse itself. Holding the first peak to ten times the repetitive one would need 1.90 Ω of winding resistance.

The first cycle, which no steady state contains

Every number this field computes about a rectifier — the ripple, the crest factor, the conduction angle, the power factor — is read from the settled state, and the march that produces them starts from an empty capacitor and throws the first cycle away. That first conduction carries 32.4 amperes against a repetitive peak of 1.23, it is 26 times larger than anything the circuit ever does again, and how large it is depends on when somebody's hand closed the switch.

power · Inrush An inrush limiter's steady state, and how little of it is still a limiter. computed by solving, not by drawing. A negative-temperature-coefficient thermistor in series with a supply, at 1 ampere of load current. The falling curve is what it dissipates at a temperature — I²R with R following the two-point β fit a catalogue prints — and the rising line is what its mounting removes. They cross once, at 83.1 degrees, and the loop gain there is -1.374: negative, so the part is stable at every current rather than below a boundary. What is left of its cold 10 ohms at that temperature is 1.937 — 19.4 per cent. The slider moves the load current, and more current leaves less resistance.

The protection that is gone by the second time

An inrush thermistor is ten ohms cold and holds the first cycle down; then the load current warms it and it settles at 83 degrees and 1.94 ohms, which is 19 per cent of what was bought. That is the design working. It is also a part that takes 198 seconds to recover half its cold resistance, against a reservoir capacitor that empties in tens of milliseconds — so a mains dip in that window hands the rectifier an unlimited inrush into an empty capacitor, which is the exact event the part is on the bill of materials for.

power · Thermal feedback

Named alongside it

The objects these essays reach for when they reach for this one.

Inrush currentReservoir capacitorCrest factorFixed pointLoop gainModel rangePower law fitStabilitySurge ratingSwitching energyThermal feedbackThermal resistance

All concepts