Circuit Response
every model has an edge, and the figure carries it
Concept

Common-mode choke — where it appears

Two windings on one core, wound so a current going the same way through both meets their full inductance and one going opposite ways meets almost none. It is fitted to a pair or a cable to attenuate common-mode current while passing the signal, and how deep it attenuates is set by its core loss and by the circuit around it.

Named by 2 essays across one field — each of them below, with the objects they name alongside it.

One part, two corners: 3.98 kHz to the common mode and 7.86 MHz to the signal. computed by solving, not by drawing. Two windings on one core with a coupling of 0.999, driven twice from the same netlist — once with the two conductors in opposition, which is the signal, and once with them in parallel, which is everything the cable picked up. The mode that goes the same way round both windings meets (1+k)L and is down three decibels by 3.98 kHz; the mode that goes opposite ways meets the leakage, (1−k)L, and is untouched until 7.86 MHz. The ratio is 1975, which is 2/(1−k) and contains no inductance at all. Neither number is computed here: both modes are driven and the answer is read.

The inductor one mode cannot see

Two windings on one core present a millihenry to a current that goes the same way round both and a microhenry to one that goes opposite ways, so the same component has a corner at 3.98 kHz and another at 7.86 MHz — a ratio of two thousand, which is 2/(1−k) and contains no inductance at all. It is bought to remove the conversion the previous essay measured, and five picofarads across each winding turn it over at 1.59 MHz and leave it worth 0.02 decibels by ten gigahertz.

lines · Common-mode choke A core loss of 100 kΩ gives the resonance a floor at −66 dB, and by 10.0 GHz the choke is worth 0.02 dB. computed by solving, not by drawing. The common mode at the load, in decibels against the same circuit with no choke in it, with 5 pF across each winding and a core loss of 100 kΩ across each, drawn over the lossless curve. At the winding's resonance, 1.59 MHz, the inductance and the capacitance cancel and what is left is the loss, so the deepest point is 66.02 dB — 20·log(1 + (Rp/2)/(Zs + Zl)), with no inductance and no capacitance in it. Above the resonance the part is a capacitor across the path it was fitted to block, and by 10.0 GHz it attenuates 0.02 dB.

The depth a resonance does not have

The inductor one mode cannot see printed its choke's best attenuation as 102 decibels at 1.59 megahertz. Swept with 1,999, 2,000 and 2,001 samples the same lossless part reports 110.0, 96.3 and 103.6 decibels, because a resonance with nothing to dissipate has no bottom and a sweep reports how near its nearest sample fell. Give each winding a core loss and the depth is 20·log(1 + (Rp/2)/(Zs + Zl)) — 66.02 decibels at a hundred kilohms, twenty more per decade of loss, with no inductance and no capacitance in it, and half of it belonging to the circuit the choke sits in.

lines · Common-mode choke

Named alongside it

The objects these essays reach for when they reach for this one.

Self-resonanceCommon-mode rejectionDifferential modeElectromagnetic compatibilityGrid convergenceInsertion lossLeakage inductanceMagnetic lossMode conversionModel refusalMutual inductanceParasitics

All concepts