Circuit Response
every model has an edge, and the figure carries it
Concept

Complex power — where it appears

The product of a phasor voltage and the conjugate of its phasor current, whose real part is dissipated and whose imaginary part is not. Summed over the sources and summed over the elements it agrees in both halves for any network at all, so that agreement checks the assembly rather than the model.

Named by 2 essays across one field — each of them below, with the objects they name alongside it.

A 20 Ω, 50 mH load on 230 V at 50 Hz. computed by solving, not by drawing. The load draws 1636 W and 1285 var, an apparent power of 2080 VA at a power factor of 0.786. The reactive side is confirmed by a route that touches no impedance: 2ω times the energy stored in the inductor gives 1285 var. The cable carries 9.04 A and only 7.11 A of it does anything.

The current that does no work

A solved network has been reporting its own real power on every page of this collection, as the second of the two checks each answer passes before it is drawn. What that check discards is the imaginary half — the power that flows out to a reactance and back again, does nothing, and is still carried by the cable, still heats the transformer, and is still on the bill.

power · Reactive power Correcting a 20 Ω, 50 mH load to unity, and what it stores. computed by solving, not by drawing. A capacitor across a 230 V, 50 Hz supply is swept from nothing to 300 µF against a load drawing 1636 W and 1285 var. The reactive power falls through zero at 77.31 µF and keeps going; the energy stored in the installation rises from 2044.9 mJ to 4089.7 mJ at that point — exactly twice, because unity power factor means the two stores are equal — and goes on rising afterwards. Only the cable current has a least value, 7.113 A against 9.044 A.

The energy a unity power factor doubles

Reactive power was computed three ways on this site and the agreement was called a verification. Two of the three are one theorem written twice and cannot disagree about anything; only the third is independent, and what it computes is a difference. Correcting a 20 Ω, 50 mH load to a power factor of 1.000000 takes its reactive power from 1,285 var to nothing and takes the energy stored in the installation from 2,044.9 mJ to 4,089.7 mJ — exactly twice, at every load and every frequency.

power · Reactive power

Named alongside it

The objects these essays reach for when they reach for this one.

Reactive powerApparent powerEnergy-storageGyratorNullorPower factorPower factor correctionQuality factorReal powerSeries resonanceSynthetic inductorVerification

All concepts