Concept

Transfer curve — where it appears

The output a device gives against the input applied to it, whose curvature is the whole of what a linear model of that device leaves out. Sampled at a cosine drive and transformed, it gives every harmonic at once, which is how a distortion measurement is made here rather than derived.

Named by 5 essays across 2 fields — each of them below, with the objects they name alongside it.

An exponential driven 10.0 mV either side of its bias. computed by solving, not by drawing. A sinusoid in, and out comes a waveform whose peaks are taller than its troughs are deep. The second harmonic is 9.61% of the fundamental, measured by transforming 512 samples and predicted independently as I₂(0.387)/I₁(0.387) = 9.61%. The two routes agree to 5e-10 over the 5 harmonics that stand above the arithmetic's own floor, and share nothing but the amplitude.

The distortion a linear model cannot have

A small-signal model's output is a scaled copy of its input by construction, so it has no second harmonic and asking it for one is not a hard question but a meaningless one. Measured on the curve itself, an exponential produces one per cent of harmonic distortion at 1.03 mV of drive — seven times sooner than the 7.30 mV at which its gain is one per cent wrong.

semiconductors · Distortion
What a 0.7 V constant costs, in the quantity it is used to predict. computed by solving, not by drawing by Newton's method on the exponential at 94 supplies through four resistors. The model is exact at 5.748 mA — the current at which the true drop is 0.7 V — and every curve crosses zero there, at four different supplies. Below it the model is low and above it high, and how much depends on the headroom rather than on the diode. Through the 87 Ω curve the drop is 49 mV out at 0.725 V and 147 mV out at 150.7 V — a factor of 3.0 — while the error in the current falls from -66% to 0.10%, a factor of 674, because the headroom underneath it has grown by 2017. On that curve the model is inside one per cent only above 1.12 V.

The one current a constant is right at

Seven-tenths of a volt is the true forward drop at 5.748 milliamperes and at no other current, and every circuit built on it crosses zero error there — four different resistors at four different supplies, all exact at the same current. What decides whether the model is any good is not the diode at all; it is how much of the supply the diode is taking.

limits · Diode model
An exponential with 6× of degeneration: both edges move, and not together. computed by solving, not by drawing at 61 amplitudes. Total harmonic distortion reaches one per cent at 36.6 mV and the gain falls one per cent short of its small-signal value at 85.0 mV. An emitter resistor dividing the gain by 6 moves the distortion edge by 35.4 times — the square of the factor, because the resistor both divides the drive reaching the junction and linearises what the junction does with it — while the gain edge moves by only 11.6 times. So the two edges close up: 2.32 times apart here against 7.06 bare, and a well-degenerated stage stops being limited by its linearity and starts being limited by how accurately its gain is known.

What a resistor in the emitter buys

Degeneration is described as a trade: give up gain, get linearity. Measured on the transfer curve, the two sides of that trade are not the same size. Dividing the gain by six moves the amplitude at which distortion reaches one per cent by thirty-five times — the square of the factor — and the amplitude at which the gain is one per cent out by only twelve. So the two edges close up, and a well-degenerated stage stops being limited by its linearity and starts being limited by how accurately its gain is known.

semiconductors · Emitter degeneration
An exponential with 6× of degeneration: both edges move, and not together. computed by solving, not by drawing at 61 amplitudes. Total harmonic distortion reaches one per cent at 36.6 mV and the gain falls one per cent short of its small-signal value at 85.0 mV. An emitter resistor dividing the gain by 6 moves the distortion edge by 35.4 times — the square of the factor, because the resistor both divides the drive reaching the junction and linearises what the junction does with it — while the gain edge moves by only 11.6 times. So the two edges close up: 2.32 times apart here against 7.06 bare, and a well-degenerated stage stops being limited by its linearity and starts being limited by how accurately its gain is known.

Where the two exponents come from

What a resistor in the emitter buys measured two exponents and could explain neither: the distortion edge moves as the square of the degeneration factor and the gain edge as its 0.950 power, and at a factor of exactly three halves the gain error vanished. The degenerated transfer curve has no closed form forwards and an exact one backwards, and reverting that series gives all three. The distortion exponent is exactly two; the gain edge is proportional to D squared over the root of the absolute value of three minus twice D, which is infinite at three halves and tends to a three-halves power; and the two edges are 7.07 apart on the bare device and 1.62 at a factor of eleven, against 7.06 and 1.61 measured.

semiconductors · Emitter degeneration
At 300 K one junction holds a logarithm to ±1% over 2.4 decades as a diode and 8.5 at its collector. computed by solving, not by drawing. The voltage of one model junction against the logarithm of the current it carries, as a percentage error of that current from a straight line fitted over the widest range that stays within ±1%. Taken as a diode — both mechanisms and 0.6 Ω of series resistance — the range is 2.40 decades, from 50.1 nA to 12.6 µA, and its slope is an ideality of 1.982. Taken at the collector, where the recombination current is supplied from the base and 1.604 Ω remains, it is 8.50 decades, from the axis's own end at 1 pA to 316 µA, at an ideality of 1.0001. Nothing arrives beside the collector current, so its lower end on this axis is the axis.

The logarithm is in the collector

A diode is the textbook logarithm, and a real junction holds one to within one per cent over only 2.40 decades — from 50 nanoamps to 12.6 microamps, at an ideality of 1.98 — because two mechanisms and a series resistance share its terminals. The same junction read at a transistor's collector, with its recombination current supplied from the base, holds 8.50 decades at an ideality of 1.0001. How far the logarithm reaches is decided by which terminal the current is taken from, and at the bottom of the range by a leakage current a millivolt is enough to switch on.

limits · Diode model

Named alongside it

The objects these essays reach for when they reach for this one.

Gain compressionTotal harmonic distortionEmitter degenerationLinearisationLocal feedbackModel rangeOperating pointSaturation currentThermal voltageBessel functionsBulk resistanceDevice matching

All concepts