Circuit Response
every model has an edge, and the figure carries it
Concept

Quadrature — where it appears

The addition of two quantities as the root of the sum of their squares, which is what independent contributions to one total make. It is the right arithmetic when the two share no phase angle — two uncorrelated noise sources, or two error waveforms at right angles — and it understates the total whenever they do share one.

Named by 8 essays across 3 fields — each of them below, with the objects they name alongside it.

Superposition holds for the solution and not for its square. computed by solving, not by drawing, at 81 settings of the second source. Two ten-volt sources reach one hundred-ohm load through a hundred ohms each. Every node voltage and every branch current is the sum of the two single-source solves to 3.8e-16 of itself — superposition, exactly. The power is not: the difference is 2·Re(I₁·conj(I₂))·R to 1.0e-15, and at 0° between the sources and equal size it is 444.4 mW against the 222.2 mW that adding gives. Adding the two powers is within one per cent of the truth only when one source is below 0.00505 of the other. The slider is the angle between them: at 90° the two curves coincide to the last bit, and at 180° the true power falls to zero while the sum does not.

Two solves that add, and the one that does not

Every node voltage and every branch current in a linear network is the sum of the per-source solves, here to the last bit of a double at eighty-one settings. The power is not, and the gap is not a correction: two equal sources in antiphase put nothing at all into a load while adding their powers gives 222 milliwatts, and the sum is within one per cent of the truth only when one source is two hundred times the other.

networks · Superposition Two of the three are one mechanism at 19.0°; the third arrives at ninety. computed by solving, not by drawing. The cosine between each pair of error waveforms at 30.0 kHz, against how much output the ideal model is asked for. Bandwidth and slewing sit at 0.9454 — 19.0 degrees — and close only slowly, reaching 0.8813 at 16 V. Clipping does not exist below 12.00 V, where its error is 4.0e-9 per cent of the signal and its direction is the direction of rounding; above it the mechanism is real — 18.1 per cent at the top of the sweep — and its cosine against both of the others stays under 0.0025. The bandwidth error is 0.615 per cent at every amplitude here, unchanged to 5.3e-15, because a linear stage's fractional error has no amplitude in it.

Where the mechanisms are one mechanism

An amplifier is said to run out of three separate things — bandwidth, slew rate and rails — and errors from separate mechanisms add in quadrature while errors from one mechanism add as magnitudes. Measured as waveforms rather than as numbers, two of the three sit 18.4349 degrees apart, which is exactly the angle between a sinusoid and its own cube, and the third sits at ninety: its cosine against both of the others stays under 0.0025 wherever it exists. So the arithmetic is neither of the two anybody reaches for, and a budget built the right way is within 2.9 per cent where quadrature is 17 per cent low and a straight sum 37 per cent high.

limits · Small-signal A hold capacitor's band closes at 6.43 MHz, where a resistor's does. computed by solving, not by drawing. The switch of 0.5 Ω closed, 100 MΩ open and 5 pF across it, driving a capacitor. The lower edge is the smallest capacitance onto which the open switch feeds through no more than 1%: 495 pF far above 318 Hz, rising as the reciprocal of frequency below it because the leakage charges the capacitor. The upper edge is the largest capacitance the closed switch tracks to 1%, counted as a vector. The two meet at 6.43 MHz; a resistor on the same switch closes at 6.43 MHz, and counted as a magnitude the capacitor's band closes at 91.6 MHz. At the closure the closed switch's phase is 0.57 degrees.

The width no load can change

A switch's band was drawn against a load resistor and closed at 6.43 megahertz. Put a hold capacitor where the resistor was and the band changes axis and shape — a diagonal below 318 hertz, a floor of 495 picofarads above it — and stays exactly as wide: 1.8083 decades at 100 kilohertz for both loads, closing at 6.43 megahertz for both. Count the capacitor's error as a magnitude, as the resistor's always was, and the band appears to stay open to 91.6 megahertz. That extra room is 8.11 degrees of lag the count cannot see.

limits · Ideal switch Where 8 channels leak to: 91.0 MHz from buffered sources, 901 kHz from 50 Ω. computed by solving, not by drawing. The frequency at which the open channels of a multiplexer built from the 0.5 Ω, 100 MΩ, 5 pF switch leak 1% of the signal onto the shared output, against the impedance of the source driving the selected channel, into 1 MΩ. 2 channels: 637 MHz buffered, 6.30 MHz from 50 Ω; 8 channels: 91.0 MHz buffered, 901 kHz from 50 Ω; 16 channels: 42.4 MHz buffered, 420 kHz from 50 Ω. Each falls as the reciprocal of the source impedance plus the on-resistance, and the single switch's own band closes at 6.43 MHz.

Where an open switch leaks to

A lone switch has a band whose width no load can change, because its open state leaks into the load. In a multiplexer the seven open channels leak into a node the selected channel holds, so the load leaves the answer and the source takes its place: one per cent of leak at 91.0 megahertz from buffered sources and 901 kilohertz from fifty ohms, moving as the first power of the tolerance rather than the second. Adding the channels' capacitance into one forty-picofarad switch puts it at 804 kilohertz, near the fifty-ohm figure by coincidence and a hundred and thirteen times low for a buffered one.

limits · Ideal switch From 50 Ω into 50 Ω: a T isolates to 643 MHz, a changeover to 6.34 MHz. computed by solving, not by drawing. The fraction of the drive that arrives with the path open, against frequency, from a 50 Ω source into 50 Ω, for the 0.5 Ω, 100 MΩ, 5 pF switch used three ways. A T reaches 1% at 643 MHz; a changeover reaches 1% at 6.34 MHz; one switch reaches 1% at 3.18 MHz.

The capacitance a third switch moves

A changeover's open channel leaks into the source of the channel that is closed, so its isolation into fifty ohms falls from 643 megahertz with a buffered source to 6.34 megahertz with a fifty-ohm one. Put a third switch to ground between two series switches and the leak lands on half an ohm of closed switch instead: 814, 643 and 2,240 megahertz from sources of nothing, fifty ohms and a kilohm, rising forty decibels a decade where a changeover's rises twenty. The price is the shunt switch's own capacitance, moved under the closed path, which makes the T one per cent wrong as a waveform at 6.59 megahertz beside the changeover's 6.61.

limits · Ideal switch One rms value, and a peak that moves 41 per cent with a phase. A 10 V fundamental and a 3.33 V 3th harmonic, summed, with the harmonic's relative phase swept. The two are orthogonal over a period, so the root-mean-square value is the quadrature sum 7.45356 V at every phase — to 6.2e-15, which is the one case superposition allows and is a theorem rather than an approximation. The peak is not a sum of anything: it runs from 9.428 V to 13.33 V, a factor of 1.414, against a bound of 13.33 V that it reaches exactly at 180° — where this harmonic's own crest lands on the fundamental's, which for n ≡ 3 (mod 4) is that end of the sweep and not the other. At the far end it flattens the crest to 9.428 V, and there the peak has no closed form at all. So one signal has one heating and a headroom requirement that varies by 41 per cent, decided by a phase that no magnitude spectrum carries.

The peak that only has a bound

Power does not superpose and the gap has a closed form — two times the real part of one current times the conjugate of the other, exact at every setting. A peak has nothing of the kind. A ten-volt fundamental with a third harmonic a third its size has one root-mean-square value, 7.454 volts at every relative phase because the two are orthogonal, and a peak running from 9.428 to 13.333 volts across the same sweep — reaching the sum of the two peaks exactly at 180 degrees, where the harmonic's own crest lands on the fundamental's, and having no closed form at all at the other end.

networks · Superposition Adding powers is wrong by the number of sources, when they are coherent. computed by solving, not by drawing, at five source counts. 8 ten-volt sources reach one hundred-ohm load through a hundred ohms each. With every source in phase the load takes 790.1 mW against the 98.77 mW that adding their separate powers gives — exactly 8 times, at every count, to a part in 10¹², because all 28 cross terms are positive and equal. With seeded random phases it takes 0.9865 times the sum over 64 runs, against a standard error of 0.125 — the cross terms average to nothing, which is the reason noise powers add and a root-sum-square is the right arithmetic for uncorrelated interference. The factor between the two limits is the source count itself, so it grows without bound: adding powers is not wrong by a bounded amount, it is wrong by how many things are being added.

The cross terms that outnumber the sources

With two sources the power in a load has one cross term, and adding the separate powers is wrong by a factor of two. With thirty-two there are four hundred and ninety-six of them, and the factor is thirty-two: 940 milliwatts delivered against the 29.4 that adding gives. With the same thirty-two sources at seeded random phases it is 26.9 milliwatts — the sum itself, inside the standard error of sixty-four runs, because every cross term averages to nothing. One identity, two limits, and the two are a phased array's gain and a noise sum's.

networks · Superposition A 1 kHz tone burst through a band-pass of Q = 10, centred on its resonance. computed by solving, not by drawing, marched twice — sine and cosine carriers — so the output's envelope is the modulus of the two, exactly. The input envelope (pale) peaks at 240 ms; the output's (dark) at 243.171 ms, 3.171 ms late. The group delay at resonance is 2Q/ω₀ = 3.183 ms. The phase there is zero, so the carrier itself is not delayed at all.

The envelope that leaves early

A band-pass's group delay at its centre is the delay of an envelope, not of a carrier. Marched twice — on a sine and a cosine carrier, so the envelope is their modulus exactly — a 1 kHz burst through a band-pass of Q = 10 comes out 3.171 ms late against 2Q/ω₀ = 3.183, while the carrier's zero crossings come out within 6.4 µs of where they went in. Through a notch, whose group delay at its centre is −3.810 ms, the envelope peaks 3.746 ms before the input's. Neither is a paradox, and both hold only for bursts long against the inverse bandwidth: 60.6 per cent wrong at 0.6 of it, 0.7 per cent at 20.

filters · Group delay

Named alongside it

The objects these essays reach for when they reach for this one.

Model rangeDesign tradeoffSuperpositionLoadingOff isolationOn-resistanceParasiticsReal powerNonlinearitySource impedanceVerificationCrest factor

All concepts