Concept

Charge amplifier — where it appears

An inverting amplifier with a capacitor as its feedback element, which converts a charge delivered to its input into an output voltage of charge over capacitance. It reads piezoelectric and capacitive sensors, and a bleed resistor across the capacitor sets its lowest usable frequency.

Named by 2 essays across 2 fields — each of them below, with the objects they name alongside it.

A 1% mismatch in the cable reads as 3.0% of full-scale displacement, at every frequency. computed by solving, not by drawing. A capacitive displacement sensor — two 10 pF plates driven at ±5 V in antiphase facing a common electrode — read by a charge amplifier through two metres of three-conductor cable with 30 pF a metre between each excitation conductor and the sense conductor. With the two cross-capacitances mismatched by 1 per cent and the sensor centred, the reading's in-phase part (solid) is 3.00 per cent of full scale at every carrier from 100 Hz to 1 MHz: the cable is a sensor capacitance, and its mismatch a displacement. The quadrature part (dashed), which the cable's resistance makes, rises with frequency and a synchronous detector rejects it. With each conductor in its own screen the cross-capacitance is gone and so is the error.

The sensor that is the capacitance

Read a capacitive displacement sensor through the same kind of cable that limited a strain-gauge bridge's carrier, and the roles exchange. On the bridge, a 1% mismatch in the cable's capacitance was a quadrature leak that grew as the square of the carrier and could be escaped by a lower one. On a sensor of two 10 pF plates it is 3.0% of full-scale displacement, in phase, at every carrier from 100 Hz to 1 MHz — because a capacitance between an excitation conductor and the sense conductor is in parallel with the measurand and is a sensor capacitance. No detector phase separates it and no carrier escapes it; only geometry does. Screen each conductor separately and there is nothing left to mismatch.

applied · Bridge

An integrator of 100 kΩ and 1 µF with its input grounded: what its own input currents do to it. computed by solving, not by drawing, marched for ten seconds from rest. With 50 nA flowing out of each input and the + input grounded, the output ramps at 50.0 mV/s — the bias current over the capacitance, to six figures — and reaches 0.500 V. With 100 kΩ in the + input to balance the resistances, only the 5 nA of offset current is left and the ramp is 5.00 mV/s. Neither stops: an integrator has no gain to quote, because its gain is time.

The current a capacitor adds up

An amplifier's input current in a resistor is an offset; in a capacitor it is a rate, and time is the gain. An integrator of 100 kΩ and 1 µF with its input grounded ramps at 50.0 mV/s from 50 nA, and balancing the inputs leaves the 5.00 mV/s of the offset current, still unbounded. A leak resistor bounds it at the current times the leak and costs the lowest frequency the circuit integrates. A hold capacitor's droop times its acquisition time is fixed, so 50 nA through a 100 Ω switch needs 655 nF and 0.77 ms for half a 16-bit step. A charge amplifier's offset times its low corner is Ib/2πCf, whatever its bleed.

instruments · Input bias current

Named alongside it

The objects these essays reach for when they reach for this one.

Capacitive sensor Closed form Corner frequency Design tradeoff Device mismatch Guarding Input bias current Integrator Leakage current Marching Measurement error Offset voltage

All concepts